Installation of DGPS receiver
Procedure
1.Dismount chassis assembly from panel/chassis assembly by disconnecting the connector and PH8P from J8 on MAIN Board shown in the figure below.
AView
Remove two ties.
Cable w/8P connector
J8
J7
(P)MAIN
A | ANLG Board | |
14P0313B | ||
| ||
| Connector |
MAIN Board
14P0311B
Panel assembly
Figure 4-2 Dismounting chassis assembly
2.Dismount heat sink from chassis assembly by unfastening three screws on the ANLG board, loosening two screws at TR fixing plates and disconnecting the connector of the mini pin coaxial cable.
ANLG Board | Screws (3 X 8), 3pcs. |
|
Mini pin | Heat Sink | |
coaxial cable | ||
|
TR fixing plate