Fig. 1
6
Charging the ONIX 110 Battery
Before using your ONIX 110 for the first time, the internal rechargeable battery must be fully charged, via the USB port on the unit. Connect the supplied USB cable to the ONIX 110, then connect the other end of the cable to the AC Charger. Plug the charger into an AC wall outlet, and allow the unit to charge until the battery charge icon on the unit’s display indicates a full charge (this typically takes
Turning On For the First Time
To turn on your ONIX 110 Handheld GPS Navigator, press and hold the Power button for two seconds. The product info page is displayed, then the Mode Selection menu appears. Use the navigation keys to select a mode (see “Using the ONIX 110 Modes” on the next page) and press the OK button. Press the Menu button twice and select Satellite. The unit will start acquiring satellite information. Note: When the ONIX 110 is used indoors, the device may not receive a sufficient GPS signal and a warning message will appear on the screen. This warning message does not go off unless you select “GPS Off” in the Menu.
Acquiring Satellite Information
The satellite page displays information obtained from the GPS satellites (Fig. 1). The upper half of the screen displays the satellites found in the vicinity and their respective numbers.
The vertical bars on the bottom of the screen show the signal strengths acquired from the satellites. The GPS requires at least 4 satellites to determine its position, then the position coordinates are displayed at the bottom of the screen. Note: For optimal performance, the ONIX 110 must have its position determined by the satellites.
Viewing the Map Page
Press the Page button to toggle between the map page and the navigation info tabs page. On the map page, a triangle icon indicates your current location and the “house” icon indicates your home location. Press the Menu button to start navigation.