Roland XP-80 quick start File name Song Name, PTNSET11.SVQ

Page 17

No.

File name

Song Name

10

PTNSET01.SVQ

Acid Set

11

PTNSET02.SVQ

Acid Swing Set

12

PTNSET03.SVQ

Dancehall Set

13

PTNSET04.SVQ

Euro Beat Set

14

PTNSET05.SVQ

Funk Set

15

PTNSET06.SVQ

Ground Beat Set

16

PTNSET07.SVQ

Hip Hop Set

17

PTNSET08.SVQ

House Set

18

PTNSET09.SVQ

Jazz Set

19

PTNSET10.SVQ

Lovers Set

20

PTNSET11.SVQ

Trance Set

The produsers of all songs are Mitsuru Sakaue and Kiyotaka Takiyama. Copyright © 1995 Roland Corporation

Roland Corporation holds the copyrights to all the Phrases of these Patterns. You may use these Phrases when creating new works of your own without requesting permission from Roland. Roland Corporation, however, assumes no responsibility or liability whatsoever with regard to any infringements upon the copyrights of any third parties that may result through your use of these materials.

Refer to page 36 for the profile of the Producer.

<Procedure>

Insert the demo disk into the disk drive.

Press [SEQUENCER].

Make sure that the cursor is located at the song number, and select the demo song that you wish to hear, either by turning the VALUE dial, or by pressing [INC]/[DEC] to select the song number from 10–20.

If the cursor is elsewhere, move it using [u] or [d].

Press [STOP/PLAY].

No sound will play, but the sounds to be used for Pattern playback will be selected. By putting the XP-80 in playback mode, you can synchronize the timing at which each Pattern will begin playback.

Press various keys to play back the Patterns, referring to the figure below.

As long as you keep the key pressed, the pattern continues to play back. You can play back up to eight Patterns simultaneously.

 

Bass

Fil in

Others

 

C2

 

 

Stop

Drum

Bass

 

The keys assigned to each pattern will vary slightly depending on the pattern collection select- ed.

To interrupt playback of the pattern, press a key lower than C2.

To stop playback, press [STOP/PLAY] again.

17

Image 17
Contents Quick Start Names and functions of buttons and controls Sequencer section Numeric keys Volume sliderDisplay Value dialMidi connectors Power switchAC inlet Output MIX R jack, Output MIX L jackConnect your XP-80 To turn power off Turn the power onDemo song Composer Play a demo songTo change panning To modify the volume level of each PartTo modify effects settings Select and play Patches Reset to default factory settingsPlay sounds Play percussion sounds from the keyboard Velocity/Aftertouch Try out performance functionsSolo Play arpeggios Arpeggiator Listen to the demo songs Try out the demo diskCombine Patterns for playback Play back a pattern by pressing specific keys RPSPTNSET11.SVQ File name Song NameFile name Add rhythmic ‘feel’ to the songsTry out some user groove templates Template Explanation Playing songs in sequence Chain Play Select a Performance Record a songClear internal memory Record the drums using realtime recordingHigh tom Closed hi-hat Low tom Bass drum Snare drum Page View the recorded data Record the bass using step recordingPage Record the melody using realtime recording Bank Assign a new name to the Performance Create an appropriate Performance for the songSelect a different Patch for the melody Temporary area Store the PerformanceFormat a disk Save your new songSave your song to disk DanceKit Demo Songs for RPS Demo SongsPerformance user Patch user Alex Wurman Profiles of composers