Presetting the Controls Before Use

Since sudden high output levels from your Pyle Pro mixer can damage not only audio devices connected to the mixer output but your hearing as well (especially if you are using headphones), please adjust the mixer’s controls BEFORE connecting AC power or turning on the unit.

Set up the mixer controls like this before you start:

CONTROL	SETTING

Power On/Off	OFF
Balance	MID
Tone Controls, Treble, Mid and Bass	0
MIC 1/2, CH 1/2/3, Master and Cue Levels	0
Crossfader	CENTER

Connecting the Outputs

After presetting the controls (above), you can then connect the mixer’s output jacks to the output devices’ input jacks. Before connecting these devices, however, be sure to preset their controls to avoid any damage to your equipment due to unexpected high output levels.

Set the output devices’ controls like this before you start:

OUTPUT DEVICE	CONTROL	SETTING

Tape Deck	POWER	OFF
Amplifier/Receiver	POWER	OFF
	TONE	FLAT

Playing the Mixer’s Output Signal

To play the mixer’s output signal through your speaker system (for events such as parties, dances, conferences, etc.) connect an audio patch cord (not supplied) from the mixer’s MASTER L and R jacks to your receiver’s left and right input jacks. This mixer permits you to choose cables with either RCA jacks or 1/4” jacks for this connection, but do not use both sets of jacks simultaneously.

Recording the Mixer’s Output Signal

To record the mixer’s output signal, connect audio patch cords (not supplied) from the mixer’s REC (Record) L and R jacks to your tape deck’s left and right input jacks.

Monitoring the Mixer’s Output signal in the DJ Booth

To monitor the mixer’s output on a second set of speakers in the DJ booth (or in a remote location), connect an audio patch cord from the mixer’s ZONE L and R jacks to the additional amplifier’s left and right input jacks.(PYD-1005)

Pyle Pro Mixer Owner’s Manual - 3