Connecting the Mixer Inputs (cont.)
3.Turntables. Connect up to 2 turntables to the Phono 1 and Phono 2 input jacks.
When using a turntable, you should also securely connect its ground wire (usually green or black) to the Ground screw on the input panel of the mixer.
Use RCA type patch cables
Magnetic cartridge turntable
LEFT output
RIGHT output
GROUND wire from turntable
Connecting the Lamp
If you wish to intall a console lamp (not supplied), simply insert the plug end of an appropriate 12V/3W gooseneck style or similar lamp into the lampsocket provided in the upper right corner of the mixer control panel. Power is supplied to this lamp when the mixer power switch is turned on.
Using Headphones
12V/3W lamp
Plug a pair of stereo headphones (not supplied) with a 1/4” plug into the Phones output. Using headphones not only affords you the opportunity to listen privately, but also enables you to monitor the incoming audio sources so you can locate an exact passage or section before mixing it in. It also gives you the opportunity to set up the relative volume level of the upcoming passage before it joins the mix.
Stereo Headphones
Listen Safely! Please observe the following:
Do not listen at extremely high volume levels. Extended,
Always start by setting the volume level to the lowest possible level before listening.
Put headphones on, and then gradually increase the volume as necessary.
Once you set the volume level do not increase it. Over a period of time, your ears adapt to a volume level and there is a temptation to increase it. Even though such an increase may not cause discomfort, it might still damage your hearing.
Pyle Pro Mixer Owner’s Manual – 5