Samson XP1000 owner manual Position the speakers on the floor or on stands

Page 14

Setting Up the XP1000

Position the speakers on the floor or on stands.

For maximum sound coverage the XP1000 can be used with a standard 13⁄8” speaker stand. The speaker should be raised above the heads of the listening audience. Take care when placing the speaker on a stand, to ensure that it is on a level, steady surface and will not tip over. When using the speaker on the floor, or when the speaker is below the listener, the XP1000 features a monitor angle position to project the sound up, towards the audience.

Using one of the included speaker cables, connect the mixer’s LEFT SPEAKER OUT to the left speaker’s input connector. Next, use the second included speaker cable to con- nect the RIGHT SPEAKER OUT to the right speaker’s input connector.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents XP1000 Page Important Safety Information Accordance with the installation instructions FCC Notice Contents Introduction Features XP1000 Mixer Layout Channel Input Jacks channels 1Equalizer control knobs XP1000 Mixer Layout Pairing with a Bluetooth device Setting Up the XP1000 Carefully hold the mixer to remove it from the speakerPosition the speakers on the floor or on stands Quick Start XP1000 Quick Start Applying Effects Avoiding FeedbackStage XPD1 Wireless System Optional WirelessStage XPD1 Wireless System Optional XP1000 Connections Wiring Guide XLR Balanced ConnectorSpecifications Dimensions and WeightBlock Diagram
Top Page Image Contents