DigiTech DL-8 manual Tap Tempo Delay

Page 12

Tap Tempo Delay

The HardWire Delay/Looper’s Foot Switch can be used as a Tap Tempo switch for setting the delay time during a live performance.

To access Tap Tempo, do the following:

1.While the delay effect is bypassed, press and hold the Foot Switch for 3 seconds.The effect turns on and the Indicator LED lights solid RED. After 3 seconds of holding the Foot Switch, the Indicator LED begins flashing GREEN.The flashing GREEN LED indicates Tap Tempo mode is now active and the LED flashes at the current delay time’s duration.

2.Tap the Foot Switch at least two times to set a new delay time.The last two pedal tap intervals set the delay time.The TIME knob is disabled when Tap Tempo is active, and the delay cannot be bypassed until the Tap Tempo is exited.

3.To exit Tap Tempo, press and hold the Foot Switch for 3 seconds until

Image 12
Contents Page Declaration of Conformity Warranty Page Introduction Included ItemsPage Time Knob Controls the amount of delay time specified by What Does This Do?Page Page Page Page Tap Tempo Delay Page Loop Delay Page Tails Switch Page Amplifier Setup Effects Setup Battery Operation Foot Switch HardWire Performance Accessories Hook-and-loop Pedalboard Pad Foot Switch Glow Sticker StompLock Specifications 22 PS200R-240 240V~ 50Hz