Panasonic AG-MX70P manual 3015 Wht, Audio Video Input settings, Setting method

[Setup] initial setting screen

[Audio Video Input] settings

These are used to set the audio and video inputs.

When [Setup] is selected using the rotary 2 control and [Enter] is pressed, [OK?] appears so press [Enter] to change to the setting mode. Use [Shift] + [Enter] to cancel.

When [Default] is selected using the rotary 2 control and [Enter] is pressed, [OK?] appears so press [Enter] to change to the default setting.

When [V-Link] is selected using the rotary 2 control and [Enter] is pressed, [OK?] appears so press [Enter] to change operation so that the audio input is matched with the video input.

Factory settings

R1	R2	R3	R4	R5
Audio	Input
Video	Setup
	Setup
	Default
	V-Link

VS-1 V S-2 V S-3 V S-4 V S-5 V S-6 V S-7 V S-8

Event	ME Time		Pattern	INT
00E	10:00F		3015	Wht
Audio Video Input Setup			Enter to EXIT
1	V S-1	Video	A S-1	Analog
2	V S-2	Video	A S-2	Analog
3	V S-3	Video	A S-3	Analog
4	V S-4	Video	A S-4	Analog
5	V S-5	Video	A S-1	Analog
6	V S-6	Video	A S-2	Analog
7	V S-7	Video	A S-3	Analog
8	V S-8	Video	A S-4	Analog
AUXin			Mic
R1	R2	R3	R4	R5

Video

YC

Y Pb Pr

SDI

Analog

SDI

AS-1 A S-2 A S-3 A S-4

Mic

AUX2

Setting method

Press the button of the cross point to be set. Alternatively, select the button of the cross point which is to be set using the rotary 1 control. The lamp of the selected button flashes, and the bus is automatically output to Preview. When the cross point has been selected using the rotary 1 control, the A bus is output to Preview.

Select V S-1, V S-2, V S-3, V S-4, V S-5, V S-6, V S-7 or V S-8 as the video input using the rotary 2 control. Select [Video] composite, [YC], [Y Pb Pr] component or [SDI] using the rotary 3 control.

Except for [Video], the sources extend from S-1 to S-4 so [5] is changed to [1], [6] to [2], [7] to [3] and [8] to [4]. If the setting operation is exited part of the way through, the settings performed so far will not be stored in the memory. They are entered using [Enter], and operation returns to the [Audio Video Input] settings.

Select A S-1, A S-2, A S-3 or A S-4 as the audio input using the rotary 4 control. Select [ANALOG] or [SDI] using the rotary 5 control.

Video input combinations that cannot be set: S-5 to S-8 + YC/Y Pb Pr/SDI

Audio input combinations that cannot be set: Combination of SDIs with different source numbers Example: SDI of S-1 for video and SDI of S-2 for audio

[Mic] or [AUX2] can be set for [AUXin] using the rotary 4 control. The default setting is [Mic].

54