Kawai CA 111 manual Product should be connected to

Page 5

Page

5

WARNING - When using electric products, basic precautions should always be followed, including the following.

WARNING Indicates a potential hazard that could result in death or serious injury if the product is handled incorrectly.

The product should be connected to

120V

230V

240V

If you are going to use an AC power cord,

an AC outlet of the specified voltage.

make sure that it has the correct plug shape

 

 

 

 

 

 

 

and conforms to the specified power voltage.

 

 

 

 

Failure to do so may result in fire.

Do not insert or disconnect the power

 

 

 

Doing so may cause electric shock.

cord plug with wet hands.

 

 

 

 

The chair must be used properly (it must be

 

 

 

Doing so may cause the chair to fall over or your

used only when playing the product).

 

 

 

fingers to be trapped, resulting in injury.

Do not play with it or stand on it.

Only one person is allowed to sit on it.

Do not sit on it when opening the lid.

Re-tighten the bolts occasionally.

When using the headphones, do not listen for long periods of

time at high volume levels.

Do not lean against the keyboard.

Do not disassemble, repair or modify the product.

When disconnecting the AC power cord’s plug, always hold the plug

and pull it to remove it.

The product is not completely disconnected from the power supply even when the power switch is turned off. If the product will not be used for a long time, unplug the AC power cord from the AC outlet.

Doing so may result in hearing problems.

Doing so may cause the product to fall over, resulting in injury.

Doing so may result in product breakdown, electric shock or short-circuit.

Pulling the AC power cord itself may damage the cord, causing a fire, electric shock or short-circuit.

Failure to do so may cause fire in case of lightning.

Failure to do so may over-heat the product, resulting in fire.

This product may be equipped with a polarised line plug (one blade wider than the other). This is a safety feature.

If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet.

Do not defeat the safety purpose of the plug.

It is a good practice to place the instrument near the AC outlet and to place the power cord plug in a position that allows the plug to be disconnected easily in the event of an emergency. Electricity is always charging while the plug is in the AC outlet even when the power switch is in the ‘OFF’ position.

Image 5
Contents Part Names Functions Page Table of Contents Important Safety Instructions Product should be connected to Do not stand on the product or exert excessive force Instruction for AC power cord U.K ‘ Control BOX Part Names & FunctionsUsed to indicate that the control panel is turned on Basic Operation Plug the CA111 power plug into the electric wall outletPlay the piano ‘ Performing with HeadphonesInternal Sounds Single Sound ModePress the Dual button again to deactivate Dual mode Dual ModePress the Reverb button to activate the reverb simulation ReverbPress the EQ button once again to deactivate the EQ Press the EQ button to activate the EQ mode‘ Activating the Metronome ‘ Adjusting the Metronome TempoPress the Metronome button to activate the metronome ‘ Deactivating the Metronome ‘ Adjusting the Metronome Volume‘ Changing the Metronome Time Signature Press the Rec button to activate the recorder Recording a SongSelect the desired sound for the performance Press the Play/Stop button to stop recording Press the Sound button to deactivate playback mode Press the Play/Stop button to activate playback modePlaying Back a Song Press the Play/Stop button once again to stop playbackDeleting a Song Press the Sound button to deactivate delete modePress the Play/Stop and Rec buttons simultaneously Press the Rec button to delete the selected song‘ List of Demonstration Pieces Demo ModePress the EQ and Menu buttons simultaneously ‘ Listening to Demonstration Pieces‘ Menu Function List Menu FunctionsDual Balance Press the Dual button to activate Dual modePress the Menu button to select the Dual Balance function Press the Sound button to exit the Dual Balance menuPress the Sound button to exit the Voicing menu VoicingPress the Sound button to exit the Damper Resonance menu Play the piano while using the damper pedalDamper Resonance Press the Sound button to exit the String Resonance menu String ResonanceG B F G C G C E G C D E G C Press the Sound button to exit the Key Off Effect menu KEY OFF EffectPress the Sound button to exit the Touch menu TouchTemperament Temperament = EqualP.only ÇÈ S T Value button Press the Sound button to exit the Temperament menuPress the Sound button to exit the Key of Temperament menu KEY of TemperamentPress the Sound button to exit the Tuning menu TuningPress the Sound button to exit the Stretch Tuning menu Stretch TuningPress the Sound button to exit the Transpose menu Transpose‘ Midi Overview Midi Channel¡ Midi Examples „ Midi Program Change numbers Press the Sound button to exit the Midi Channel menuPress the Sound button to exit the Local Control menu Local ControlMetronome Volume Press the Rec button to confirm saving of the user memory User MemoryPress the Rec button to restore the default factory settings Factory Reset‘ about the USB Driver ‘ about the USB Connector‘ Notes on USB Usage Appendix ‘ SpecificationsFunction Transmitted Recognised Remarks Page KPSZ-0234 OM1015E-S0804 Version.1