Pioneer SX-SW330, S-ST330, HTP-330 operating instructions Standard surround setup, Bracket

Page 6

01Speaker Setup Guide

Standard surround setup

This is a standard multichannel surround sound speaker setup for optimal 5.1 channel home theater sound.

The center speakers can be installed independently in the center if desired.

2(When mounting center speakers to right and left) Stack the speakers and fix with the bracket. Each speaker is provided with a color-coded indicator on the model label on the rear side to assist identification. Refer to the color indicators and install the speakers correctly.

Center

Front left

Listening position

Center

Front right

Receiver

subwoofer

Model label

 

Left

 

Right

 

 

Green

Center speaker

Green

 

 

 

 

 

 

Color indicator

White

Front speaker

Red

 

 

 

 

As shown in the illustration, stack the speakers with the front speaker on the bottom and center speaker on top, then align the 1st and 3rd screw holes from the top of the bracket with the upper screw holes on the back of the speakers, and fasten the two securely.

Bracket

Surround left

Surround right

*When center speakers are placed in the center.

Front

Front

left

right

Center

1Attach the smaller non-skid pads to the base of each of the front, center and surround speakers. The four large non-skid pads are for the receiver subwoofer (as shown).

Use the adhesive side of the pads to attach them to the base (flat surface) of each speaker.

Non-skid pads

 

(small) x 24

Front, Center and Surround speakers

 

Non-skid pads (large) x 4

Receiver subwoofer

6

Center speaker

Front speaker

Screw

 

Caution

Do not attempt to carry the speakers when they are connected with the bracket. Doing so may cause damage to the bracket or worsen damage to the bracket and speakers in the event they are dropped.

3 Connect the speaker system.

Refer to Connecting up to connect the speakers properly. After connecting everything, place the speakers as shown in the diagram above for optimal surround sound. After placing the speakers, run the Auto MCACC setup (page 15) to complete your surround sound setup.

En

Image 6
Contents HTP-330 Thank you for buying this Pioneer product Operating EnvironmentContents Safety precautions when setting up Speaker Setup GuideSpeaker Setup Guide Chapter Home theater sound setupSubwoofer as shown Speaker Setup GuideAttach the smaller non-skid pads to the base Use the adhesive side of the pads to attach them toStandard surround setup BracketPrecautions Speaker Setup Guide Wall mounting the speakersAdditional notes on speaker placement Before mountingBasic connections Connecting upConnecting up Chapter FM antenna AM loop antennaAssemble the AM loop antenna Connect each speaker Connecting upCable To Receiver subwoofer Connect the AM and FM antennas1Cable Surround left Blue Receiver subwooferSpeaker system To AC outletUsing this system for TV audio Connect the power cord.2Display unit Controls and displaysControls and displays Chapter DisplayControls and displays Remote control Controls and displays Using the remote control Putting the batteries in the remote controlGetting started System demo settingUsing the Auto Mcacc setup for optimal surround sound Getting started ChapterListening to your system Auto listening modeDolby Pro Logic II Music settings Listening to your system ChapterUsing the Sound Retriever Listening to your system Using Front Stage Surround AdvanceUsing Advanced Surround Listening in stereoListening to your system Using Quiet and Midnight listening modesAdjusting the bass and treble Enhancing dialogueListening to the radio Listening to the radio ChapterListening to the radio Setting then press Enter to confirm Changing the frequency step‘AM 9K/10K’, then press Enter Surround sound settings Surround sound settings ChapterUsing the Setup menu Surround sound settings Adjusting the channel levels using the test toneDual mono setting Other connections Connecting auxiliary componentsConnecting external antennas Other connections ChapterSR+ Setup for Pioneer plasma displays Automatic plasma display volume mutingOther connections Using the SR+ mode with a Pioneer plasma displayAutomatic plasma display input switching About control out connectionsAdditional information Hints on installation Additional information Installation and maintenanceSetting up the remote to control your Using the TV remote control buttonsPreset code list Additional informationAdditional information Troubleshooting GeneralError Messages GlossaryTuner Additional information Specifications ST330 Speaker systemD3-4-2-1-7cAChH 使用測試音調整聲道位準 接收重低音 (SX-SW330)包裝箱:揚聲器 ( S-ST330)包裝箱: 請確認包裝箱內有下列項目的物品。設置時應注意的安全措施 揚聲器設置指南揚聲器設置指南 家庭劇院音效設置將較小的防滑墊黏貼於每個前置、中置與環繞揚聲器 堆疊揚聲器並使用支架固定。揚聲器系統接線。 標準環繞設置 用支架固定。固定前 揚聲器設置指南 將揚聲器固定於牆上關於揚聲器擺設的其他注意事項 前置、中置和環繞揚聲器有固定孔,可用於將揚聲器固定 於牆上。AM 迴路天線 02 接線 基本連接FM 天線 顯示連接線固定顯示裝置的墊塊並連接。 System Connector 插孔。連接線 至接收重低音 組裝 AM 迴路天線。 連接所有揚聲器。右環繞 (灰色) (綠色) 右前置 (紅色) 聆聽位置 連接線 左環繞 (藍色) 左前置 (白色) 至AC 電源插座 02 接線揚聲器系統 完成連接時,調整連接線位置。如果揚聲器以支架固 定,請如圖所示將連接線固定在支架的溝槽中。將電視上的音效輸出插孔連接到接收重低音的 使用此系統作為電視音效輸出接上電源線。2 Analog 輸入插孔。顯示裝置 控制與顯示03 控制與顯示 顯示幕控制與顯示 遙控器 輸入選擇按鍵03 控制與顯示 使用遙控器 裝入遙控器電池打開遙控器背面的電池槽蓋。 請依照指示( , ),將兩顆 AA/R6 乾電池放入 電池槽中。 闔上電池蓋。 開始操作 按下 SETUP。將麥克風接上後面板的 Mcacc Setup MIC 插孔。 按下 MCACC。自動聆聽模式 使用系統收聽音效05 使用系統收聽音效 以環繞音效聆聽以立體聲聆聽 使用系統收聽音效 使用前段環繞聲模式使用 「先進環繞聲」功能 使用 「聲音修正器」功能使用 「寂靜」及 「午夜」聆聽模式 05 使用系統收聽音效 使用 「音場補正等化」功能加強對白 調整低音及高音收聽廣播 收聽廣播06 收聽廣播 改變頻率間隔選擇以立體聲或多聲道播放來源。 完成後按下 ENTER。使用 左/右游標 按鍵,選擇 DRC,然後按 下 ENTER。 DRC MID - 適中設定值 CH1 Mono (預設)- 僅播放聲道 CH2 Mono - 僅播放聲道按下 Test TONE。 連接附屬裝置 其他接線其他接線 聆聽外接音效來源電漿顯示器自動靜音功能 08 其他接線 將此裝置連接先鋒電漿顯示器先鋒電漿顯示器的 SR+ 設定 先鋒電漿顯示器電漿顯示器自動輸入切換 關於控制輸出連接SR+ 模式與先鋒電漿顯示器搭配使用 按下遙控器上的 SR+。 使用 左/右游標 按鍵,選擇 SR+ ON,然後 按下 ENTER。其他資訊 CD TYPE,然後按下 ENTER。STANDBY/ON 按鍵。 設定遙控器以控制電視機 TV Volume 用於調整電視機音量 TV Channel 用於轉換電視機頻道其他資訊 安裝與維護 安裝提示09 其他資訊 預設代碼表其他資訊 故障排除 問題 解決辦法詞彙表 錯誤訊息96K 擴大器部分 SX-SW330音效多聲道接收重低音前置/環繞揚聲器 中置揚聲器 AM 調諧器部分Pioneer Corporation

HTP-330, S-ST330, SX-SW330 specifications

The Pioneer HTP-330, S-ST330, and SX-SW330 represent a sophisticated home theater system designed for audio enthusiasts seeking an immersive sound experience. These units combine cutting-edge technologies with user-friendly functionality, making them ideal for both movie lovers and music aficionados.

The HTP-330 is a complete home theater package that includes a receiver, subwoofer, and satellite speakers. One of its standout features is the incorporation of Dolby TrueHD and DTS-HD Master Audio decoding, which ensures lossless audio quality for high-definition video formats. This enables users to experience cinema-like sound right in their living rooms, enhancing the impact of movies and TV shows.

The S-ST330, with its sleek design, offers a stylish addition to any home décor. Featuring multiple amplification channels, it provides an impressive output that fills larger spaces with dynamic sound. The speakers are engineered with high-quality drivers, ensuring clear highs and deep lows, which are essential for a balanced audio experience.

One of the significant technological advancements in this series is the integration of HDMI connectivity. The HTP-330 supports multiple HDMI inputs, allowing seamless switching between various devices, such as gaming consoles, Blu-ray players, and streaming devices. This simplifies the setup process and reduces cable clutter, giving users a more organized home theater environment.

The SX-SW330 subwoofer complements the system with its powerful low-frequency output, providing a solid foundation for music and cinematic soundtracks. With its adjustable crossover frequency and phase control, users can customize the bass response to match their specific preferences and room acoustics.

Another prominent feature is the easy setup process facilitated by auto-calibration technology. The receiver can automatically adjust the speaker settings based on the room’s unique acoustics, saving users time while ensuring optimal sound performance.

Wireless technology is also a hallmark of these components, with options for Bluetooth and Wi-Fi connectivity. This allows users to stream music directly from their smartphones or tablets without the hassle of wires, enhancing convenience and flexibility.

In summary, the Pioneer HTP-330, S-ST330, and SX-SW330 deliver exceptional audio performance wrapped in a stylish and modern package. With their advanced features, such as high-definition audio decoding, HDMI connectivity, and adjustable subwoofer settings, these systems are perfect for anyone looking to elevate their home entertainment experience. Whether hosting a movie night or enjoying a concert, these units provide a captivating sound environment that satisfies even the most discerning listeners.