Pioneer S-ST330 Speaker Setup Guide Wall mounting the speakers, Before mounting, Precautions

Page 7

Speaker Setup Guide

Wall mounting the speakers

The front, center and surround speakers have a mounting hole which can be used to mount the speaker on the wall.

Before mounting

Remember that the speaker system is heavy and that its weight could cause the screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall you intend to mount the speakers on is strong enough to support them. Do not mount on plywood or soft surface walls.

Mounting screws are not supplied. Use screws suitable for the wall material and support the weight of the speaker.

Caution

If you are unsure of the qualities and strength of the wall, consult a professional for advice.

Pioneer is not responsible for any accidents or damage that result from improper installation.

5 mm

10 mm

5 mm to 7 mm

Additional notes on speaker placement

Install the main front left and right speakers at an equal distance from the TV.

When using the Front surround setup, separate the left and right speakers by about 1.5 m for optimum effect.

When using the Standard surround setup, install the surround speakers slightly above ear level for optimum effect.

Precautions:

When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker.

The front (x2), center (x2) and surround (x2) speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens, turn the power switch of the television set OFF, and turn it ON after 15 min to 30 min. If the problem persists, place the speaker system away from the television set.

The receiver subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Magnetic storage media (such as floppy discs and tape or video cassettes) should also not be kept close to the receiver subwoofer.

Do not attach the receiver subwoofer to the wall or ceiling. They may fall off and cause injury.

For safety, make sure that there is no exposed bare speaker wire outside of the speaker terminals.

Do not connect the supplied speakers with any other amplifier. This may result in malfunction or fire.

Do not connect any speakers other than those supplied to this system.

01

English

7

En

Image 7
Contents HTP-330 Operating Environment Thank you for buying this Pioneer productContents Home theater sound setup Speaker Setup GuideSpeaker Setup Guide Chapter Safety precautions when setting upUse the adhesive side of the pads to attach them to Speaker Setup GuideAttach the smaller non-skid pads to the base Subwoofer as shownBracket Standard surround setupBefore mounting Speaker Setup Guide Wall mounting the speakersAdditional notes on speaker placement PrecautionsFM antenna AM loop antenna Connecting upConnecting up Chapter Basic connectionsConnect the AM and FM antennas1 Connecting upCable To Receiver subwoofer Assemble the AM loop antenna Connect each speakerTo AC outlet Receiver subwooferSpeaker system Cable Surround left BlueConnect the power cord.2 Using this system for TV audioDisplay Controls and displaysControls and displays Chapter Display unitControls and displays Remote control Putting the batteries in the remote control Controls and displays Using the remote controlGetting started Chapter System demo settingUsing the Auto Mcacc setup for optimal surround sound Getting startedListening to your system Chapter Auto listening modeDolby Pro Logic II Music settings Listening to your systemListening in stereo Listening to your system Using Front Stage Surround AdvanceUsing Advanced Surround Using the Sound RetrieverEnhancing dialogue Using Quiet and Midnight listening modesAdjusting the bass and treble Listening to your systemListening to the radio Chapter Listening to the radioListening to the radio Changing the frequency step Setting then press Enter to confirm‘AM 9K/10K’, then press Enter Surround sound settings Chapter Surround sound settingsUsing the Setup menu Adjusting the channel levels using the test tone Surround sound settingsDual mono setting Other connections Chapter Connecting auxiliary componentsConnecting external antennas Other connectionsAutomatic plasma display volume muting SR+ Setup for Pioneer plasma displaysAbout control out connections Using the SR+ mode with a Pioneer plasma displayAutomatic plasma display input switching Other connectionsAdditional information Using the TV remote control buttons Additional information Installation and maintenanceSetting up the remote to control your Hints on installationAdditional information Preset code listGeneral Additional information TroubleshootingGlossary Error MessagesTuner ST330 Speaker system Additional information SpecificationsD3-4-2-1-7cAChH 請確認包裝箱內有下列項目的物品。 接收重低音 (SX-SW330)包裝箱:揚聲器 ( S-ST330)包裝箱: 使用測試音調整聲道位準家庭劇院音效設置 揚聲器設置指南揚聲器設置指南 設置時應注意的安全措施堆疊揚聲器並使用支架固定。 將較小的防滑墊黏貼於每個前置、中置與環繞揚聲器揚聲器系統接線。 用支架固定。 標準環繞設置前置、中置和環繞揚聲器有固定孔,可用於將揚聲器固定 於牆上。 揚聲器設置指南 將揚聲器固定於牆上關於揚聲器擺設的其他注意事項 固定前顯示連接線 02 接線 基本連接FM 天線 AM 迴路天線組裝 AM 迴路天線。 連接所有揚聲器。 System Connector 插孔。連接線 至接收重低音 固定顯示裝置的墊塊並連接。完成連接時,調整連接線位置。如果揚聲器以支架固 定,請如圖所示將連接線固定在支架的溝槽中。 02 接線揚聲器系統 右環繞 (灰色) (綠色) 右前置 (紅色) 聆聽位置 連接線 左環繞 (藍色) 左前置 (白色) 至AC 電源插座Analog 輸入插孔。 使用此系統作為電視音效輸出接上電源線。2 將電視上的音效輸出插孔連接到接收重低音的顯示幕 控制與顯示03 控制與顯示 顯示裝置輸入選擇按鍵 控制與顯示 遙控器裝入遙控器電池 03 控制與顯示 使用遙控器打開遙控器背面的電池槽蓋。 請依照指示( , ),將兩顆 AA/R6 乾電池放入 電池槽中。 闔上電池蓋。 按下 MCACC。 按下 SETUP。將麥克風接上後面板的 Mcacc Setup MIC 插孔。 開始操作以環繞音效聆聽 使用系統收聽音效05 使用系統收聽音效 自動聆聽模式使用 「聲音修正器」功能 使用系統收聽音效 使用前段環繞聲模式使用 「先進環繞聲」功能 以立體聲聆聽調整低音及高音 05 使用系統收聽音效 使用 「音場補正等化」功能加強對白 使用 「寂靜」及 「午夜」聆聽模式收聽廣播 收聽廣播改變頻率間隔 06 收聽廣播完成後按下 ENTER。 選擇以立體聲或多聲道播放來源。使用 左/右游標 按鍵,選擇 DRC,然後按 下 ENTER。 CH1 Mono (預設)- 僅播放聲道 CH2 Mono - 僅播放聲道 DRC MID - 適中設定值按下 Test TONE。 聆聽外接音效來源 其他接線其他接線 連接附屬裝置先鋒電漿顯示器 08 其他接線 將此裝置連接先鋒電漿顯示器先鋒電漿顯示器的 SR+ 設定 電漿顯示器自動靜音功能按下遙控器上的 SR+。 使用 左/右游標 按鍵,選擇 SR+ ON,然後 按下 ENTER。 關於控制輸出連接SR+ 模式與先鋒電漿顯示器搭配使用 電漿顯示器自動輸入切換CD TYPE,然後按下 ENTER。 其他資訊STANDBY/ON 按鍵。 安裝提示 TV Volume 用於調整電視機音量 TV Channel 用於轉換電視機頻道其他資訊 安裝與維護 設定遙控器以控制電視機預設代碼表 09 其他資訊問題 解決辦法 其他資訊 故障排除錯誤訊息 詞彙表96K 中置揚聲器 AM 調諧器部分 SX-SW330音效多聲道接收重低音前置/環繞揚聲器 擴大器部分Pioneer Corporation

HTP-330, S-ST330, SX-SW330 specifications

The Pioneer HTP-330, S-ST330, and SX-SW330 represent a sophisticated home theater system designed for audio enthusiasts seeking an immersive sound experience. These units combine cutting-edge technologies with user-friendly functionality, making them ideal for both movie lovers and music aficionados.

The HTP-330 is a complete home theater package that includes a receiver, subwoofer, and satellite speakers. One of its standout features is the incorporation of Dolby TrueHD and DTS-HD Master Audio decoding, which ensures lossless audio quality for high-definition video formats. This enables users to experience cinema-like sound right in their living rooms, enhancing the impact of movies and TV shows.

The S-ST330, with its sleek design, offers a stylish addition to any home décor. Featuring multiple amplification channels, it provides an impressive output that fills larger spaces with dynamic sound. The speakers are engineered with high-quality drivers, ensuring clear highs and deep lows, which are essential for a balanced audio experience.

One of the significant technological advancements in this series is the integration of HDMI connectivity. The HTP-330 supports multiple HDMI inputs, allowing seamless switching between various devices, such as gaming consoles, Blu-ray players, and streaming devices. This simplifies the setup process and reduces cable clutter, giving users a more organized home theater environment.

The SX-SW330 subwoofer complements the system with its powerful low-frequency output, providing a solid foundation for music and cinematic soundtracks. With its adjustable crossover frequency and phase control, users can customize the bass response to match their specific preferences and room acoustics.

Another prominent feature is the easy setup process facilitated by auto-calibration technology. The receiver can automatically adjust the speaker settings based on the room’s unique acoustics, saving users time while ensuring optimal sound performance.

Wireless technology is also a hallmark of these components, with options for Bluetooth and Wi-Fi connectivity. This allows users to stream music directly from their smartphones or tablets without the hassle of wires, enhancing convenience and flexibility.

In summary, the Pioneer HTP-330, S-ST330, and SX-SW330 deliver exceptional audio performance wrapped in a stylish and modern package. With their advanced features, such as high-definition audio decoding, HDMI connectivity, and adjustable subwoofer settings, these systems are perfect for anyone looking to elevate their home entertainment experience. Whether hosting a movie night or enjoying a concert, these units provide a captivating sound environment that satisfies even the most discerning listeners.