Pioneer SSP-LX70ST, SX-LX70W manual Adjusting the channel levels using the test tone, LFE Attenuate

07Surround sound settings

Using the Virtual Surround Back mode

This mode allows you to hear a virtual surround back channel through your surround speakers. You can choose to listen to sources with no surround back channel information, or if the material sounds better in the format (for example, 5.1) for which it was originally encoded, you can have the receiver only apply this effect

to 6.1 encoded sources like Dolby Digital EX or DTS-ES.1

		ENTER
1	SETUP	Open the ‘Sound Setup’ menu.
	ENTER
2		Select ‘Virtual SB’, then press ENTER.

Adjusting the channel levels using the test tone

If you prefer, you can set the channel levels using a test tone as a reference, rather than playing a source (see Channel level setting on page 30). A test tone is played through each speaker in turn, allowing you to adjust the level as it plays.

You can also adjust the channel levels for surround sound using test tone.

TEST

1 TONE Carry out tone testing.

The test tone is output from each speaker in turn. Adjust the volume level below 50.

3 Select a setting.

Select one of the following:

•Vir.SB On – Virtual Surround Back is always used (for example, on 5.1 encoded material)

•Vir.SB Auto – Virtual Surround Back is automatically applied to 6.1 encoded sources (for example, Dolby Digital EX or DTS-ES), DTS Neo:6 or Advanced Surround mode

•Vir.SB Off – Virtual Surround Back mode is switched off

4 ENTER Press to exit.

LFE Attenuate

Some Dolby Digital and DTS audio sources include ultra- low bass tones.

Set the LFE attenuator as necessary to prevent the ultra- low bass tones from distorting the sound from the speakers.

The LFE is not limited when set to 0dB, which is the recommended value. When set to -5dB, -10dB, -15dBor -20dB, the LFE is limited by the respective degree. When Off is selected, no sound is output from the LFE channel.

2	Adjust the channel level of a tune while it
is playing.

The aim is to adjust the levels so that you hear the test tone at the same volume from each speaker. You can adjust the level of each channel by ±10 dB.

•You can adjust the overall volume of test tone output using the VOL +/– buttons (this does not affect the channel level settings).

•Because of the ultra low frequencies the subwoofer produces, it may sound quieter than it really is. We suggest adjusting the subwoofer level while listening to a source. See the method described in Channel level setting on page 30.

3 ENTER Press to exit test tone setup once you have finished.

•If you use the Auto MCACC feature again, it will overwrite the settings you have made here.

		ENTER
1	SETUP	Open the ‘Sound Setup’ menu.
	ENTER
2		Select ‘LFE ATT’, then press ENTER.
	ENTER
3		Adjust the setting then press ENTER to
confirm.

Note

1 Depending on the input signal and the listening mode, the Virtual Surround Back mode may not be effective.

32

En