Changing Navigation Track
After you record, the display shows the contents of the last recorded or edited track. To display a different track, re- peatedly press TRANSPOSE/TUNE/MIDI until Bend appears, then press 
until Navi. Tr. appears. Then press + or – until the track you want appears on the display.
EDITING MEMORY
CONTENTS
You can recall and change individual notes and parameter settings (such as tone number) in memory contents.
Follow these steps to edit memory con- tents.
1.Repeatedly press MEMORY until Play No. appears.
2.Within 5 seconds, use + or – to select a song number.
3.Press STEP.
4.Use the MEMORY TRACK/DRUM PAD buttons to select the track you want to edit.
5.Repeatedly press 
or 
to move to the entry point you want to change.
You can change the parameter that is flashing on the display. To change
a different parameter, press 
so the parameter you want to edit starts flashing.
Make the desired changes to the selected parameter.
The actual procedures you use to change a parameter depend on the type of data it contains. See “Editing Techniques and Display Contents” on Page 40.
Notes:
•Do not change a note identical to the preceding or succeeding note. Doing so might alter the length of the note and you will have to re- record the entire track.
•When you change note, key pres- sure, chord, or drum pad data, the keyboard sounds the new setting so you can hear what it sounds like.
6.Repeat Steps 5 and 6 to edit other parameters.
7.Press MEMORY, STEP, or START/ STOP when you are finished.
Notes:
•When you interrupt playback of a song and immediately start an edit- ing operation, the entry point (or point of interruption) appears on the editing screen.
•The only parameters that can be edited for Tracks
•You cannot add data to a recording.
•You cannot move portions of a recording to a different location within the recording.
•You cannot change note lengths.
39