Important Notes When Moving the Unit

This equipment is heavy (weighing 44 kilograms), so to prevent injury and other safety hazards due to accidental toppling, drops, or falls, at least two persons should work together to carry the unit when moving it.

Use and Handling of the Casters

The KC-880 comes with casters, which can be useful when moving the unit.

Attaching and Removing the Casters

When attaching or removing the casters, give attention to the following points.

• Carry out the operation at a location that is level and stable.

• To ensure safety, at least two persons should work together to carry out the operation.

• Exercise care to keep fingers or feet from being pinched or pinned.

• When attaching or removing the casters, to avoid damaging the unit or the floor surface, place stacked newspapers or the like under the unit.

• When placing the unit on the floor on its side, handle with care to avoid dropping it, or allowing it to fall or tip over.

When moving this equipment, carry it while securely gripping the left and right handles as shown in the figure.

Using the included casters can be convenient on level surfaces.	1.	Place the KC-880 on the floor on its side as
		shown in the figure.
	2.	Attach the casters to the unit (or detach the
		casters).
	3.	Return the unit to its upright position.

Turning the Power On and Off

*Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.

*Before switching off the power, lower the volume on each of the devices in your system and then TURN OFF the devices in the reverse order to which they were switched on.

1.Make sure that all volume controls on the KC- 880 and connected devices are set to 0.

2.Turn on all the devices connected to the KC- 880’s input jacks (CH 1 through CH 4 and AUX IN/MONITOR IN).

3.Turn on the KC-880.

4.Switch on any equipment connected to the KC-880’s LINE OUT jacks.

5.Adjust the volume levels for the devices.

*This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally. For protection from sudden big sound, always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a malfunction.

*If you need to turn off the power completely, first turn off the [POWER] switch, then unplug the power cord from the power outlet. Refer to “Power Supply” (p. 6).