Pioneer VSX-9110TXV-K Using multi operations, Using System off, From the menu and press Enter

11Controlling the rest of your system

6If necessary, press the input source button for the component whose command you want to input.

This is only necessary if the command is for a new component (input source).

7Select the button for the command you want to input.

The following remote control commands can be selected:

RECEIVER	INPUT		SYSTEM OFF
			SOURCE
	SELECT
					TV CONTROL
				TVVOL	INPUT	TVCH	VOL
					SELECT
CD		DVR 2
DVD	TV	DVR1	TVCTRL
CD-R/TAPE	HDMI2	XM RADIO	ROOM 2	DTVON/OFF	REC	DTVINFO
iPod	HDMI1	TUNER	RECEIVER				MUTE
				MPX		REC STOP	JUKEBOX
	SLEEP	VIDEO	ANALOG
		SEL	ATT
	SR+	DIMMER	MIDNIGHT/	AUDIO	SUBTITLE	HDD	DVD
				DISP		CH	CH
			LOUDNESS
	DIALOG E	S.RETRIEVER		STATUS	SIGNAL SEL	SBch	STEREO
D.ACCESS +10			CLASS DISC	MULTI OPE	THX	STANDARD	ADV.SURR
			ENTER
AVPARAMETER			CHLEVEL	SHIFT	PHASE	MCACC	S.DIRECT
TOPMENU			MENU
	TUNE
DTVMENU	ST	ST	T.EDIT
SETUP	ENTER		RETURN
	TUNE				RECEIVER
GUIDE CATEGORY		BAND

•You don't need to program the receiver to switch on or off. This is done automatically.

With Pioneer components, you don’t need to:

•program the power to switch off in a shutdown sequence (except DVD recorders);

•program the power to switch on if it’s the source component selected in step 3;

•program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals;

These take priority in multi operations (not shutdown).

8Repeat steps 5–7 to program a sequence of up to five commands.

9 When you’re finished, use	to select EDITEXIT
from the menu and press ENTER.

You will return to the remote control SETUP menu. Select

*EXIT * again to exit.

Using multi operations

You can start multi operations with the receiver switched on, or in standby.

AUDIO	SUBTITLE	HDD	DVD
DISP		CH	CH
STATUS	SIGNAL SEL	SBch	STEREO
MULTI OPE	THX	STANDARD	ADV.SURR
SHIFT	PHASE	MCACC	S.DIRECT

RECEIVER

1 Press MULTI OPE.

MULTI OP flashes in the display.

2Press an input source button that has been set up with a multi operation.

The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically.

Using System off

				AUDIO	SUBTITLE	HDD	DVD
			SYSTEM OFF	DISP		CH	CH
	RECEIVER	INPUT
			SOURCE	STATUS	SIGNAL SEL	SBch	STEREO
		SELECT
	AV PRE-PROGRAMMED AND LEARNING			MULTI OPE	THX	STANDARD ADV.SURR
	REMOTECONTROLUNIT
				SHIFT	PHASE	MCACC	S.DIRECT
	CD	DVR 2			RECEIVER
	DVD	TV DVR1	TVCTRL
1	Press MULTI OPE.
MULTI OP flashes in the display.
2	Press SOURCE .

The command sequence you programmed will run, then

all Pioneer components will switch off1, followed by this receiver.

Note

1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.

68

En