Boss Audio Systems RP250 user manual Expression Pedal Calibration

Page 47

Expression Pedal Calibration

The Expression Pedal on the RP250 needs to be recalibrated for use after a factory reset has been performed. This calibration procedure is automatically entered after a factory reset procedure. (You can also initiate the calibration procedure by pressing and holding both Footswitches for approximately 5 seconds.) In the event the Pedal’s calibration fails, or if the Pedal does not function properly, it can be re-calibrated using the Pedal Calibration procedure. This will not erase the User presets.The procedure for Calibrating the Expression Pedal is as follows:

1.Press and hold the Up/Down Footswitches until PDLCAL appears in the display (BYPASS and TUNER will be displayed before PDLCAL is accessed)

2.When the Display prompts you with TOE DN, rock the Expression Pedal forward (toe down) and press either Footswitch.

3.When the Display prompts you with TOE UP, rock the Expression Pedal back (toe up) and press either Footswitch.

4.The Display now prompts you to calibrate the V-Switch sensitivity (VSwxxx), where XXX is the current V-Switch threshold. Rock the Expression Pedal forward and press firmly on the toe

once to turn the V-Switch on (wah ON), and again to turn the V-Switch off (wahOFF).

5.If the V-Switch is too sensitive, press the right Up Footswitch to raise the threshold (range is

0-200). Keep testing the V-Switch sensitivity and adjust the threshold until it only engages when you want it to (too sensitive a setting will lead to the V-Switch falsely triggering on or off when using the Expression Pedal).

6.When the V-Switch sensitivity is set to your satisfaction, press both Up/Down Footswitches simultaneously to exit.

Note: If the Display shows error, an error has occurred and steps 2 through 5 should be repeated.

41

Page 46 Page 48
Image 47
Page 46 Page 48
Contents User’s Manual Page Declaration of Conformity Table of Contents Section Five Appendix Section Four Other FunctionsWarranty Included Items RP250 PS0913B Power Supply Warranty CardGetting Acquainted About the RP250 Performance ModeBypass Mode Tuner ModeDisplay shows Top LEDs indicate Master Level Knob Tone Library KnobEffects Library Knob Effects Level KnobPresets Front Panel Guided Tour of the RP250Effects Library Knob Tone Library KnobMaster Level Knob Effects Level KnobDisplay 3 4 5 6 Rear PanelPower Input Mono Operation Amplifier Making ConnectionsStereo Operation Stereo Amp SetupComputer Recording Setup Stereo Mixer SetupApplying Power Section Two Editing Functions Editing/Creating PresetsStoring/Copying/Naming a Preset Press the Store button again to save the changes About the Models Section Three Models and ParametersWah Model DefinitionsPickup Distortion CompressorDist Knob Model Gain Amplifier Page Bmn410 Based on a 4x10 ‘59 Fender Tweed Bassman Noise Gate Chorus Chorus/FXFlanger Phaser PHaseRRanges from 0 200 Hz to 99 1600 Hz Vibrato viBRaTRotary Speaker Rotary Tremolo TRMoLO VibroPan vibpanYaYa yaya Envelope Filter eNvlOpAutoYa Autoya DigiTech Whammy wHammy Step Filter stpfltPitch Shift PitCH Intelligent Pitch Shifting IPS Delay Reverb Model ReverbReverb Knob Model Drum Pattern List Drum MachineExpression Pedal Aux InputFactory Reset Expression Pedal Calibration Appendix SpecificationsDigital Connections Expression Pedal Assignable Parameters Page Tone Library Effects Library Preset List Page DigiTech South Sandy Parkway Sandy, Utah PH 801 FAX 801
Top Page Image Contents