Boss Audio Systems RP250 user manual Power Input

Page 17

4. Headphones

Connect a pair of stereo headphones to this 1/8" jack. For proper frequency response, the Amp/ Mixer switch should be set to Mixer (“In” position) when using headphones.

Note: The Headphones output can have either a mono or stereo signal, depending on what 1/4" outputs are connected. If neither (or both) 1/4" outputs are connected, the Headphones output will be in stereo. If a cable is connected to the Left (Mono) 1/4" output only, the Headphones output will be in mono.

5. Aux In

Connect the headphone output of an MP3 or CD player using a stereo 1/8" cable to this 1/8" stereo TRS jack for rehearsing with your favorite pre-recorded material. Adjust the output level of your playback device and the RP250’s Master Level knob for the proper volume balance.

6. USB Port

The USB port is for connecting the RP250 to a computer and serves two purposes: (1) for use with the downloadable X-Edit™ Editor/Librarian software, and (2) for streaming audio to and from the computer. Audio streaming is limited to 2 channels up and 2 channels down from the computer at 44.1kHz, 16 bit and 24 bit. A utility panel in the Editor/Librarian controls the direct/ playback mix with any recording software the RP250 is connected to.

Note: You can download the X-Edit Editor/Librarian software and USB drivers at www.digitech. com.

7. Power Input

Connect only the DigiTech® PS0913B power supply to this jack.

11

Image 17
Contents User’s Manual Page Declaration of Conformity Table of Contents Section Five Appendix Section Four Other FunctionsWarranty Included Items RP250 PS0913B Power Supply Warranty CardGetting Acquainted Bypass Mode Performance ModeTuner Mode About the RP250Display shows Top LEDs indicate Effects Library Knob Tone Library KnobEffects Level Knob Master Level KnobPresets Front Panel Guided Tour of the RP250Effects Library Knob Tone Library KnobMaster Level Knob Effects Level KnobDisplay 3 4 5 6 Rear PanelPower Input Mono Operation Amplifier Making ConnectionsStereo Operation Stereo Amp SetupComputer Recording Setup Stereo Mixer SetupApplying Power Section Two Editing Functions Editing/Creating PresetsStoring/Copying/Naming a Preset Press the Store button again to save the changes About the Models Section Three Models and ParametersWah Model DefinitionsPickup Distortion CompressorDist Knob Model Gain Amplifier Page Bmn410 Based on a 4x10 ‘59 Fender Tweed Bassman Noise Gate Chorus Chorus/FXFlanger Phaser PHaseRRanges from 0 200 Hz to 99 1600 Hz Vibrato viBRaTRotary Speaker Rotary Tremolo TRMoLO VibroPan vibpanYaYa yaya Envelope Filter eNvlOpAutoYa Autoya DigiTech Whammy wHammy Step Filter stpfltPitch Shift PitCH Intelligent Pitch Shifting IPS Delay Reverb Model ReverbReverb Knob Model Drum Pattern List Drum MachineExpression Pedal Aux InputFactory Reset Expression Pedal Calibration Appendix SpecificationsDigital Connections Expression Pedal Assignable Parameters Page Tone Library Effects Library Preset List Page DigiTech South Sandy Parkway Sandy, Utah PH 801 FAX 801