Eaton Electrical SC200 manual Entering the sysObjectID of a Power System

Entering the “sysObjectID” of a Power System

Entering the “sysObjectID” of a Power System

“sysObjectID” is a unique identifier that allows the network management system to identify an item (in this case a power system) on the network.

The unique identifiers are listed in the table below.

APS3-058:1.3.6.1.4.1.1918.10.1

APS3-059:1.3.6.1.4.1.1918.10.2

APS3-060:1.3.6.1.4.1.1918.10.3

APS3-061:1.3.6.1.4.1.1918.10.4

APS6-058:1.3.6.1.4.1.1918.10.5

APS6-059:1.3.6.1.4.1.1918.10.6

►To enter the “sysObjectID” of a power system using DCTools

1From the DCTools System Summary (Home) screen, click the Configuration hotlink and then Communications to display the Communications view.

2Click the button to the left of SNMP and scroll down to the bottom of the SNMP view.

3Click the button to the left of sysObjectID Component to display the sysObjectID entry view.

4Enter only the last three parts of the power system’s unique identifier into the appropriate sysObjectID fields. (See Example 1 below.)

Example 1 The unique identifier of an APS6-058 power system is 1.3.6.1.4.1.1918.10.5.

The last three parts (1918.10.5) are entered as shown below.

Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.	6-5
IPN 997-00012-41D December 2006