Connecting the Battery Cables (if applicable)

Step 1 - Prepare cable clamp

Cut off the two inside posts of the battery cable clamp to enable the battery cables and sleeve to fit.

Step 2 – Strip cable and fit sleeve

Strip approximately 17mm (3/4”) of the insulation from the cable ends. We recommend fitting cable ferrules over the cable ends.

Feed both battery cables through the 16mm sleeve.

Step 3 – Terminate cable

Terminate the positive battery cable at the Battery (+) terminal block. Terminate the negative battery cable at the Battery (-) terminal block. Tighten the terminal screws. Required torque: 2.5 - 3 Nm (22.1 – 26.5 lb-in).

Ensure that the polarity at the battery terminal blocks matches the polarity of the external battery. Connecting a reverse polarity battery to a power system will cause damage to the rectifier modules. Such damage may not be covered by the warranty.

"

#

16mm battery cable sleeve.

Battery cable clamp with posts removed.

Step 4 – Arrange sleeve and clamp the battery cables

Arrange the cable sleeve so that it is within 10mm (3/8”) of the terminals. Tighten the cable clamp screws. Required torque: 1.5 – 2 Nm (13.2 – 17.7 lb-in).

Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.

3-9

IPN 997-00012-41D December 2006

 

Page 29
Image 29
Eaton Electrical SC200 manual Prepare cable clamp, Connecting the Battery Cables if applicable