Maintenance

Inserting a Rectifier

Step 1 – Align the new rectifier with the burst-out guides in the shelf

Step 2 – Push in the rectifier

To avoid injury to your hands, keep your fingers clear, as shown in the diagram below.

1Slowly push in the rectifier, until the rear connector of the rectifier engages fully with the backplane connector.

2Tighten the rectifier retaining screw.

3Check that the rectifier’s Power On LED turns on and the and alarm LEDs are off.

The alarm LED turns on for about 1 second when the rectifier powers up.

4Fit the front cover (APS3-06X desktop versions only).

Procedure complete

7-8

Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.

IPN 997-00012-41D December 2006

 

Page 62
Image 62
Eaton Electrical SC200 manual Inserting a Rectifier