PW167600AV
Injection hazard.
●Keep clear of nozzle. NEVER direct high pressure spray at any person, animal or self.
●Always wear safety glasses or goggles and protective clothing.
Explosion hazard.
●NEVER spray flammable liquids or use pressure washer in areas containing combustible dust, liquids or vapors.
Equipment damage.
●ALWAYS turn water supply “ON” before turning pressure washer “ON”. Running pump dry causes serious damage.
●NEVER allow the unit to run with the trigger released (off) for more than one minute. Resulting heat buildup will damage pump.
●NEVER store the pressure washer outdoors or where it could freeze. The pump will be seriously damaged.
●Release the trigger when changing from high to low pressure modes.
Failure to do so could result in damage to the nozzle.
●If an extension cord is needed, the appropriate wire sizes must be used (See chart).
Extension | Allowable length | |
Cord size | 25’ | 50’ |
14 AWG | Yes | No |
12 AWG | Yes | Yes |
●This unit must always be used in the horizontal position.
EXTENSION CORDS
If using an exten-
sion cord, use only grounded, three wire extension cords that are in good condition.
Use only extension cords that are intend- ed for outdoor use. These extension cords are identified by a marking “Acceptable for use with outdoor appli- ances; store indoors while not in use”. Use only extension cords having an elec- trical rating not less than the rating of the product.
Do not use damaged extension cords. Examine extension cord before using and replace if damaged. Do not abuse exten-
sion cord and do not pull on the cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the cord from the receptacle before discon- necting the product from the extension cord.
Note: Do not use 16 or 18 AWG exten- sion cords on this product.
Installation
Instructions
Tools Required for Installation:
●Flat Screwdriver
●Hammer/Mallet
●Adjustable Wrench
1.Set plastic spacer (included in parts pack) on workbench (Figure 1).
Figure 1
2.Place “star shaped” retaining ring on the spacer (tangs pointing down) (Figure 2).
Figure 2
3.Tap the retaining ring onto the axle (Figure 3 & 4).
Figure 3
Figure 4
4.Put both wheels on axle, solid sides together (Figure 5).
Figure 5
5.Attach opposite ring in the same manner (Figure 6).
Figure 6
6.Slide wheels out and snap axle into place on the underside of body (Figure 7).
7.Snap wheel covers on the wheel.
8.Attach foot to front of pressure wash- er body (Figure 7).
Figure 7
9.Hook up chemical suction hose to the tip on the bottom of the handle (Figure 8).
Figure 8
10.Attach black handle with enclosed screws and washers (Figure 9).
Figure 9
3