Power switch is used to turn the amplifier on and off

V-50H Guitar Amplifier

Thank you for choosing Ampeg. In order to obtain the best performance from your new ampli- fier we recommend you review the information in this owner’s guide prior to its use.

THE FRONT PANEL:

1.Power switch is used to turn the amplifier on and off.

2.Power light indicates the amplifier is turned on by glowing an iridescent blue color.

3.Reverb controls the amount of reverbera- tion applied to the signal. With the control at the “0” position there is no reverb applied; as the control is turned towards “10” the amount of reverb increases accordingly.

4.Bass adjusts the output level of the low fre- quencies and offers a cut or boost of 24dB at 50Hz.

5.Mid adjusts the output level of the middle frequencies and offers a cut or boost of 16dB at 800Hz.

6.Treble adjusts the output level of the high frequencies and offers a cut or boost of 12dB at 6kHz.

7.Gain controls the overall output level of the amplifier. At lower volume settings the sound

will be clean. As you push the volume higher and crank your guitar the sound becomes dis- torted.

8.-6dB Input accepts a standard 1/4” instru- ment plug from high output electronic instru- ments. This input is padded 6dB to compen- sate for higher output sources.

9.0dB Input accepts a standard 1/4” instru- ment plug from your electric guitar. This input is at 0dB level.

SPEAKERS

IMPEDANCE		CAUTION
		CAUTION
		RISK OF ELECTRIC SHOCK
		DO NOT OPEN
16	8	AVIS:RISQUE DE CHOC
		ELECTRIQUE. NE PAS OUVRIR.

MAIN:EXT

USE FIRST

WARNING: TO REDUCE THE RISK OF FIRE	Made in the U.S.A. by
OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS	SLM ELECTRONICS
EQUIPMENT TO RAIN OR MOISTURE.	1400 FERGUSON AVE. / ST. LOUIS, MO 63133

FOOTSWITCH

REVERB / BOOST ON–OFF

THE REAR PANEL:

10.Main Speaker jack: Use this jack to con- nect the amplifier to your speaker cabinet. Always use this jack “first” – if using a second cabinet, connect it to the Extension Speaker jack (#11).

11.Ext. Speaker jack: Use this jack to con- nect the amplifier to a second speaker cabinet

– always use the Main Speaker jack (#10) “first.”

12.Impedance switch: Use this switch to

match the amplifier to the TOTAL impedance of your speaker cabinet(s).

13.Preamp Tube: 12AX7A / 7025 (1)

14.Power Amp Phase Splitter Tube: 12AX7A / 7025 (1)

15,16. Power Tubes: EL34 / 6CA7 (2)

Replace tubes ONLY with same types! Refer to enclosed publication about Tubes and Tube Amplifiers for additional information.

17:Footswitch Jack: Connect the supplied

footswitch here for control of the Reverb on/off and a switchable 15dB of gain from 250Hz to 8kHz.

18:Power cord connects the amplifier to a suitable source of A.C. voltage. This is a grounded, three-wire cord and must be con- nected to a properly grounded outlet. DO NOT attempt to defeat the ground connection of the power cord! If your amp was purchased outside of the United States, see the sticker next to the A.C. connector for its power rat- ings. Follow the above guidelines.