Ampeg SJ-12T manual Rear Panel, 11,12. Power Tubes 6L6

Page 6

10

(Reverb cables:

11

12

13

14

15

 

do not disturb)

 

 

 

 

 

The Rear Panel:

10.Power cord connects the amplifier to a suitable source of A.C. voltage. This is a grounded, three-wire cord and must be connected to a properly grounded outlet. DO NOT attempt to defeat the ground connection of the power cord! If your amp was purchased outside of the United States, see the sticker next to the A.C. connector for its power ratings. Follow the above guidelines.

11,12. Power Tubes: 6L6 (2)

13.Power Amp Phase Splitter Tube: 12AX7A / 7025 (1)

14.Preamp Tube: 12AX7A / 7025 (1)

Replace tubes ONLY with same types! Refer to pages 7 through 10 for impor- tant information about tubes and tube products.

15:Footswitch Jack is located up inside the amplifier, just past the cabinet’s cov- ered back panel. Connect the supplied footswitch here for remote control of the Reverb and Tremolo on/off.

6

Image 6
Contents Yyyyyyyyyyy Table of Contents Declaration Of Conformity EMCFront Panel Power switch is used to turn the amplifier on and off 11,12. Power Tubes 6L6 Rear PanelImportant Information About Tubes and Tube Products Brief History Of The TubeTube Types And Usage Nature Of Tubes Why And When To Replace Them Importance Of Proper Biasing Survival Tips For Tube Amplifiers System Block Diagram SJ-12TTECHNICAL Specifications