Pioneer VSX-D411 Additional information Troubleshooting, Adjust the Master Volume, Receiver

Page 38

09 Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

Problem

Remedy

The power does not turn on.

•Connect the power plug to the wall outlet.

•Disconnect the power plug from the outlet, and insert again.

•Make sure there are no loose strands of speaker wire touching the rear panel. This could cause the receiver to shut off auto- matically.

No sound is output when a function is selected.

•Make sure the component is connected correctly (refer to pages 11–16).

•Press MUTE on the remote control to turn muting off.

•Adjust the MASTER VOLUME.

•Press the MONITOR button to turn monitoring off.

No image is output when a function is selected.

•Make sure the component is connected correctly (refer to pages 11–13).

•Select the correct component (use the INPUT SELECTOR buttons).

Considerable noise in radio	• Tune in the correct frequency.
broadcasts.	• Connect the antenna (refer to pages 14–15).
	• Route 2 RF and digital cables away from the antenna
	terminals and wires.
	• Fully extend the FM wire antenna, position for best reception,
	and secure to a wall.
	• Connect an outdoor FM antenna (refer to page 15).
	• Adjust the direction and position for best reception.
	• Connect an additional internal or external AM antenna (refer
	to pages 14–15).
	• Turn off the equipment causing the noise or move it away from
	the receiver.
	• Place the antenna farther away from the equipment causing
	the noise.

Broadcast stations cannot be	• Connect an outdoor antenna (refer to page 15).
selected automatically.

38

En

Image 38

Contents VSX-D411VSX-D511 Important Notice Page Contents Before you start Checking what’s in the box Installing the receiverOperating range of remote control unit Making cable connections02 5 minute guide Introduction to home theater Hook up your TV Minute guide Listening to Surround SoundHook up your DVD player 02 5 minute guide Connect your speakersPlay a DVD, and adjust the volume to your liking Minute guide1ch 02 5 minute guide Using the Quick Setup1ch 0ch Press EnterDigital audio cords/Optical cables Connecting upAudio/Video cords Video cables VSX-D511 onlyConnecting up Connecting digital components Connecting audio componentsSignal Connecting up Connecting DVD 5.1 channel componentsConnecting video components Arrows indicateConnecting antennas FM wire antennaAntenna snap connectors Connecting up AM loop antennaUsing external antennas To improve FM receptionSnap shut the speaker terminal to secure Connecting the speakersSpeaker terminals Hints on speaker placement Operating other Pioneer components Connecting up AC outletBy connecting a control cord optional Connected equipment should not exceed 100 W 0.8 aControls and displays Front Panel 10 11 12 13 14 15 16 17 18Display Master VolumeControls and displays DTSDirect PRO LogicATT MidnightReceiver Controls and displays Remote ControlDVD Subtitle TOP MenuAudio Standard modes Playing sources Introduction to Sound ModesStereo/Direct Advanced Surround modesPlaying sources Choosing the input signalUsing Stereo/Direct ExpandedPlaying sources Listening to multi-channel playback Using Advanced SurroundUsing Loudness and Midnight listening Pro Logic Music Pro Logic II MovieMidnight Off Loudness Using the tone controlsPlaying other sources TrebleSelect DVD/LD if it is not already selected Press Signal Select front panel repeatedly to select 5.1 chPlaying sources Selecting the multi-channel analog inputs Speaker setting Setting up the receiverChoosing your receiver setup Subwoofer settingCrossover frequency setting Speaker settingSubwoofer setting FL-C -SSCenter speaker distance setting LFE attenuator settingFront speaker distance setting Surround speaker distance set- tingCoaxial digital input setting Dynamic range control settingDual mono setting Optical digital input settingWhen you’re done, press Test Tone to turn off the test tone Setting the relative volume level of each channelUse Level +/- to adjust the speaker levels in turn Press Standard Press Test Tone to output the test toneUsing the tuner Listening to the radio Improving FM stereo sound Display shows ST. MEMORY, then a blinking memory class Using the tuner Saving station presets Tune to a station you want to memo Rize Choose the station preset you want to name Using the tuner Naming station presetsListening to station presets Press Station +/- to select the station preset you wantMaking Recordings Making an audio or a video recording Monitoring your recordingPlace the antenna farther away from the equipment causing Additional information TroubleshootingAdjust the Master Volume ReceiverRemove the obstacle or operate from another position Additional informationFront panel refer to LightVideo Section Additional information SpecificationsAmplifier Section FM Tuner Section16-9/16 W x 6-4/16 H x 15-8/16 D Power Consumption 260 WDimensions 19.8 lbAdditional information Additional information 0 4 2 1 1 4 0 TNGZF/01L00001 Printed XRB3011-A