Shure LX88-II manual LX1 Body-Pack Transmitter Features & Controls Figure, System Installation

LX1 Body-Pack Transmitter Features & Controls (Figure 3

	6	8
3	2
	ON
	MUTE BAT OFF PWR
	1
5	4	7

LX1 BODY-PACK TRANSMITTER FEATURES & CONTROLS

FIGURE 3

1.POWER ON/OFF Switch.

2.Power/Battery Fuel Gauge. Indicates the power level of the battery.

3.Input Jack. Tini ªQ-Gº input connector for microphones or instruments.

4.Mic On/Mute Switch. ªMutesº the transmitter to prevent unwanted sounds from being picked up by the receiver without turning the transmitter off.

5.Belt Clip. Secures Body-Pack to clothing or guitar strap.

6.Antenna. For best operation, the antenna must hang vertically, it should not be coiled or bundled.

7.Audio Gain Control. Provides audio level adjustment to accommodate dif- ferent sound sources.

8.Battery Compartment. Access to the battery.

4

SYSTEM INSTALLATION

MOUNTING THE RECEIVER

The LX88-IIDual Channel Wireless Receiver can be mounted in two ways: as a stand-alone unit or as a rack-mount unit.

As a Stand-Alone Unit (Figure 4)

INSTALLING RUBBER FEET

FIGURE 4

1.Turn the unit upside-down.

2.Place the rubber feet supplied with the package in the four corners of the base.

3.Turn the unit rightside-up. It can now be mounted on any flat surface, such as a table, with the feet working as anchors to prevent slipping.

As a Rack-Mount Unit

1.Remove the two screws from each side of the receiver.

2.Position the mounting brackets over the holes on the sides of the receiver and secure to the receiver with the screws from Step 1 (Figure 5).

RACK±MOUNTED RECEIVER

FIGURE 5

3.Secure the assembly to a standard audio equipment rack with four screws (Figure 6).

INSTALLING RECEIVER IN A RACK

FIGURE 6

5