BODY-PACK Transmitter Setup

LX1 Body-Pack Transmitter Battery Installation (Figure

LX1 BODY±PACK TRANSMITTER BATTERY INSTALLATION

FIGURE 14

1.With the transmitter POWER ON/OFF switch in the OFF position, press down on the OPEN side of the battery compartment cover, slide it back and flip it open.

2.Insert a new 9V alkaline battery in the compartment (DURACELL MN1604 recommended). Observe proper battery polarity (ª+/±º).

3.Close Battery compartment cover.

Operating LX1 Body-Pack Transmitters (Figure 15)

WH10
HEADSET	WM98 MIC
	& A98KCS
	HORN MOUNT

LAVALIER

MIC

WA302 INSTRUMENT

ADAPTER CABLE

LX88-II

RECEIVER

LX1 BODY±PACK SYSTEM SETUP AND OPERATION

FIGURE 15

NOTE: The LX1 body-pack system is designed for use with other equipment which is not included, such as lavalier microphones, guitars, headset micro- phones, etc. See your Shure dealer for details on ordering the proper equip- ment for your needs.

1.Clip the LX1 body pack transmitter to your belt or guitar strap.

2.Connect the lavalier microphone, headset or instrument adapter cable to the body±pack transmitter (Figure 16).

3.Press the POWER button on the LX88-IIreceiver ON.

4.Turn the transmitter POWER switch ON. Check Power/Battery fuel gauge.

5.Check the RF Signal Indicator on the LX88-IIreceiver to see if the RF signal is being received.

MICROPHONE CABLE OR

WA302 INSTRUMENT ADAPTER

CABLE

LX1 BODY-PACK TRANSMITTER CABLE CONNECTION

FIGURE 16

6.Slide the transmitter ON/MUTE switch to the ON position and begin speaking or playing your instrument.

NOTE: If the red PEAK light on the receiver does not flicker during the loud- est sounds, the transmitter gain may need to be increased. See the Trans- mitter Audio Gain Adjustment section.

7.During the performance or presentation, slide the ON/MUTE switch to the MUTE position when the system is not being used.

8.When the performance or presentation is over, slide the transmitter POWER ON/OFF switch to the OFF position to conserve battery power.