Shure UC manual Receiver Mounting, Table Mounting, Rack Mounting a Single Receiver

Page 15

ENGLISH

 

ENGLISH

 

RECEIVER MOUNTING

Table Mounting

To mount a receiver on a table or other horizontal surface, attach the four adhesive bumpers to the bottom corners of the receiver and place the receiver on the mounting surface. See Figure 20.

R

RUBBER FEET

TABLE MOUNTING THE UC4 RECEIVER

FIGURE 20

Rack Mounting a Single Receiver

To mount a single receiver in an audio equipment rack, select the single rack mounting kit supplied with the system and proceed as follows:

1.Remove the two screws from each side of the receiver. See Figure 21.

2.Position the large mounting bracket over the holes on one side of the receiver and secure them with the screws removed in Step 1. One of the brackets will be longer than the other.

UC4 RECEIVER

(TOP VIEW)

 

BRACKET

FRONT

 

ANTENNA

ANTENNA

HOLE PLUG

HOLE PLUG

EQUIPMENT RACK

UC4 RECEIVER

(TOP VIEW)

FRONT

BRACKET

RACK MOUNTING A SINGLE UC4 RECEIVER

FIGURE 21

NOTE: If you are not front mounting the antennas with a UA600 Front Mount Conversion Kit, insert the plastic plugs into the bracket holes.

3. Secure the receiver to a 19-inch audio equipment rack, using the four supplied screws.

– 13 –

Image 15
Contents UC Wireless System Table of Contents UC4 Receiver Setup UC1/UC2 Transmitter SetupSystem Operation System Description System FeaturesBattery Compartment. Holds one 9V battery UC1 Transmitter Features and ControlsUC2 Transmitter Features and Controls UC4 Receiver Controls and Connectors Transmitter Setup Checking the Transmitter BatteryReceiver Cable Connections Changing the UC2 Transmitter Battery Changing the UC1 Transmitter BatteryOperating the UC1 BODY-PACK System Changing the Transmitter Settings Adjusting the Transmitter Gain LevelOperating the UC2 HAND-HELD System Activating the UC1 Attenuator Switch Changing the Transmitter Group/Channel SettingsAdjusting the Receiver Squelch Setting Changing Receiver SettingsChanging the Receiver Group Setting Changing the Receiver Channel SettingAdjusting the Equalizer Setting Adjusting the Low-Cut Filter High PassAdjusting for High-Frequency Shelving Receiver Mounting Table MountingRack Mounting a Single Receiver Rack Mounting Two Receivers Side by Side Receiver Antenna Installation Rear Mounted Antenna InstallationFront Mounted Antenna Installation Remote Antenna Installation Logic ground is distinct from UC4 audio ground Logic Connection SpecificationsTips for Achieving Optimum Performance TroubleshootingLicensing Information SpecificationsLimited Warranty Certification101 102