Shure UC manual Remote Antenna Installation

Page 18

ENGLISH

 

ENGLISH

3.Attach the supplied UHF antennas to the BNC connectors on the front panel as shown in Figure 26. For best perfor- mance, orient the antennas with tips pointing away from each other at a 45° angle from vertical.

ATTACHING FRONT MOUNT ANTENNAS TO BNC CONNECTORS

FIGURE 26

Remote Antenna Installation

NOTE: The UA500 Remote Mount Antenna kit is sold separately.

1.Insert the two bulkhead adapters through the larger holes on each side of the front panel, and secure them from each side, using the supplied attaching hardware. See Figure 27.

2.Connect antenna cables to the receiver and the bulkhead adapters.

3.Attach Shure UA825 or UA850 low–loss antenna cable (RG–8 or equivalent) to the bulkhead adapters.

4.Connect Shure UA820A 1/2 wave antennas to the end of the antenna cables (adapter required).

5.Mount the antennas using the Shure UA500 mounting brackets. For best RF performance, do not use the supplied 1/4 wave antennas when remoting antennas. Use UA820A 1/2 wave antennas.

NOTE: For improved performance, use the optional UA830A Line Amplifier with UA845 Distribution Amplifier.

RECEIVER (TOP VIEW)

INSTALLING REMOTE ANTENNAS

FIGURE 27

– 16 –

Page 17 Page 19
Image 18
Page 17 Page 19
Contents UC Wireless System Table of Contents UC4 Receiver Setup UC1/UC2 Transmitter SetupSystem Operation System Features System DescriptionUC1 Transmitter Features and Controls Battery Compartment. Holds one 9V batteryUC2 Transmitter Features and Controls UC4 Receiver Controls and Connectors Transmitter Setup Checking the Transmitter BatteryReceiver Cable Connections Changing the UC1 Transmitter Battery Changing the UC2 Transmitter BatteryOperating the UC1 BODY-PACK System Changing the Transmitter Settings Adjusting the Transmitter Gain LevelOperating the UC2 HAND-HELD System Changing the Transmitter Group/Channel Settings Activating the UC1 Attenuator SwitchChanging the Receiver Channel Setting Changing Receiver SettingsChanging the Receiver Group Setting Adjusting the Receiver Squelch SettingAdjusting the Equalizer Setting Adjusting the Low-Cut Filter High PassAdjusting for High-Frequency Shelving Receiver Mounting Table MountingRack Mounting a Single Receiver Rack Mounting Two Receivers Side by Side Receiver Antenna Installation Rear Mounted Antenna InstallationFront Mounted Antenna Installation Remote Antenna Installation Logic Connection Specifications Logic ground is distinct from UC4 audio groundTroubleshooting Tips for Achieving Optimum PerformanceCertification SpecificationsLimited Warranty Licensing Information101 102
Top Page Image Contents