Shure manual UC2 Transmitter Features and Controls

Page 6

ENGLISH

 

ENGLISH

1

2

3

4

5

6

7

8

UC2 HAND–HELD TRANSMITTER FEATURES AND CONTROLS

FIGURE 3

UC2 TRANSMITTER FEATURES AND CONTROLS

1.Grille. Protects the microphone cartridge and helps reduce breath sounds and wind noise. The grilles for the vari- ous microphone heads differ in appearance.

2.Power Indicator/Battery Fuel Gauge. When the UC2 is turned on, one of three LEDs will glow, indicating that power is on and the amount of battery life remaining. Refer to the “Checking Transmitter Battery” paragraph for more information on battery life.

3.Power Switch. Turns the transmitter on and off.

4.Audio Gain Control. Changes the audio level to accommodate various sound sources (e.g. singing or speaking). Use the supplied screwdriver (Xcelite R3322 or equivalent) to make adjustments. Refer to the “Adjusting the Trans- mitter Gain Level” paragraph.

5.Group Setting Control (Red Switch). Rotating this switch clockwise advances the Group setting. Rotating it coun- terclockwise decreases the Group setting. Use the supplied screwdriver (Xcelite R3322 or equivalent) to change the setting.

6.Channel Setting Control (Green Switch). Rotating this switch clockwise advances the Channel setting. Rotating it counterclockwise decreases the Channel setting. Use the supplied screwdriver (Xcelite R3322 or equivalent) to make adjustments.

7.9 V Battery. Provides power to the transmitter and microphone.

8.Battery Cover. Unscrews to expose battery and Group, Channel, Gain, and Attenuation controls.

– 4 –

Image 6
Contents UC Wireless System Table of Contents UC4 Receiver Setup UC1/UC2 Transmitter SetupSystem Operation System Features System DescriptionUC1 Transmitter Features and Controls Battery Compartment. Holds one 9V batteryUC2 Transmitter Features and Controls UC4 Receiver Controls and Connectors Transmitter Setup Checking the Transmitter BatteryReceiver Cable Connections Changing the UC1 Transmitter Battery Changing the UC2 Transmitter BatteryOperating the UC1 BODY-PACK System Changing the Transmitter Settings Adjusting the Transmitter Gain LevelOperating the UC2 HAND-HELD System Changing the Transmitter Group/Channel Settings Activating the UC1 Attenuator SwitchChanging the Receiver Channel Setting Changing Receiver SettingsChanging the Receiver Group Setting Adjusting the Receiver Squelch SettingAdjusting the Equalizer Setting Adjusting the Low-Cut Filter High PassAdjusting for High-Frequency Shelving Receiver Mounting Table MountingRack Mounting a Single Receiver Rack Mounting Two Receivers Side by Side Receiver Antenna Installation Rear Mounted Antenna InstallationFront Mounted Antenna Installation Remote Antenna Installation Logic Connection Specifications Logic ground is distinct from UC4 audio groundTroubleshooting Tips for Achieving Optimum PerformanceCertification SpecificationsLimited Warranty Licensing Information101 102