ENGLISH
signal through Channel 1, as it dictates the amount of signal to the Effects Send (item 12).
Note - this will be effected by the Effect Return control (item 15) and the Master Reverb control (item 16).
Channel 2
7. Mic Input XLR
Unbalanced low impedance for microphone input.
8. Left / Mono Jack
This is for either a mono input or the left side of a stereo input if item 9 is used as well. This is a high impedance unbalanced input. Typical uses of Line Inputs are Keyboards, drum machines and sequencers.
9. Right Jack
For use with the right side of a stereo input when used in conjunction with item 8. This is a high impedance unbalanced input.
10. Volume
Controls individual volume level for channel 2. Overall volume will be governed by the Master Volume control (item 20).
12. Send Jack
For connection to the input of an external effects processor (mixed to mono).
13. Return Left / Mono Jack
For connection to the left output of a stereo external effects processor or from the output of a mono effects processor.
14. Return Right Jack
For connection to the right output of a stereo external effects processor.
15. Effect
Controls the ratio of effected to dry signal in your overall tone. Further control is given by Effect & Reverb controls on Channel 1 and Channel 2 (item 5 and item 10).
Reverb
16. Reverb
Controls master level of internal reverb.
17. Remote Jack
Allows you to switch internal reverb on and off from remote footswitch (optional extra, model no.
11. Effect & Reverb
When using the
Note - this will be effected by the Effect Return control (item 15) and the Master Reverb control (item 16).
Effects
Master
18. Low
Controls overall low frequencies of combo.
19. High
Controls overall high frequencies of combo.
20. Volume
Controls overall volume of combo. This also controls the level of the Line Out on the rear panel.
21. Power Switch
The LR230 features a parallel effects loop to | Switches the mains power to the combo and |
allow you to use external effects processors. | indicates power status. |
LR230
Rear
Panel
Features
(page
36)
1. Mains Input
For connection to the mains. We would always recommend that your plug is wired in accordance with your country’s regulations.
2. Headphone Jack
For headphone input when silent practice is the call of the day.
Note - connecting headphones will disconnect internal speakers.
Line Out
In some instances you will want to connect the LR230 to a P.A. system or to recording equipment. The Line Out level on the LR230 is controlled by the Master Volume (item 20).
3. Left
For connecting the left hand signal to a P.A. system or recording equipment.
4. Right
For connecting the right hand signal to a P.A. system or recording equipment
4