28. Effect Return
This is the master Effects Return and is an effects mix control, allowing you to decide when using an external effects processor how much of your overall sound will be effected. Further control is given by the individual Effect control which features on each channel.
30. Master Volume
The overall volume of the combo is set here. As with effects and reverb, there is an independent control on each channel allowing you to set independent volume levels for each channel. This will not however affect the level of the Line Out Phono on the rear panel (item 11).
ENGLISH
29. Master Reverb | 31. LED |
The LR300 comes complete with an | Indicates operating status of combo. |
spring reverb. The overall reverb level for the |
|
combo is set here, with independent controls |
|
featuring on each channel allowing you to set |
|
independent levels for each channel. |
|
LR300
Rear
Panel
Features
(page
40)
1, 5, 7, 8 & 9. Line Input Jack | 11. Line Out Phono |
This is a high impedance unbalanced input for | The Line Out can be used for connection to |
channels 1, 2, 3, 4 & 5 respectively. Typical uses | recording equipment for direct recording or for |
of line jack type inputs are drum machines and | connection to a P.A. system. This is not affected |
keyboards. | by the Master Volume. |
2. | Mic Input XLR - Channel 1 | 12. Send Jack |
| This is a low impedance balanced input for use | For connection to the input of an external effects |
| with microphones. | processor. |
3. | Effects Send Jack | 13. Return Jack |
| For connection to the input of an external effects | For connection to the output of an external effects |
| processor. For use on Channel 1 only. | processor. |
4. Effects Return Jack
For connection to the output of an external effects processor. For use on Channel 1 only.
6. Mic Input XLR - Channel 2
This is a low impedance balanced input for use with microphones.
10. Line Inputs Phono
These are high impedance unbalanced inputs. Typical uses of Line, phono type inputs are drum machines, C.D. players, tape deck, 4 tracks and computers.
14. Remote Footswitch
Allows you to switch internal reverb on and off from remote footswitch,
(optional extra, model no.
15. Power
Switches the mains power to the combo.
16. Mains Input
For connection to the mains. We would always recommend that your plug is wired in accordance with your country’s regulations.
7