Budda V30H manual Front Panel, Lamp This lamp illuminates when the amplifier is turned on

Page 4

G u i t a r A m p l i f i e r H E A D

The Front Panel:

1

2

3

4

5

6

7

8

9

10

11

12

13

14

1.Input: Connect your instrument here by means of a shielded signal cable.

2.Clean Volume: Use this control to adjust the output level of the Clean Channel.

3.Clean/Overdrive: This switch, when de- pressed, selects the Overdrive Channel. When this switch is in the out position, the Clean Channel is selected.

4.Overdrive Gain: Use this control to adjust the gain of the Overdrive Channel. With the control towards the counter clock- wise position, the gain is low and very little distortion is present. As you rotate the con- trol clockwise the gain increases, produc- ing more overdrive distortion and a higher output volume level.

5.Treble: Use this control to adjust the out- put level of the high frequencies. This con- trol provides 12dB of cut or boost at 6kHz.

6.Boost: This switch, when depressed, increases the output by 10dB at 900Hz, giving the middle frequencies more punch.

7.Mid: Use this control to adjust the output level of the middle frequencies. This control provides 10dB of cut or boost at 1kHz.

8.Bass: Use this control to adjust the out- put level of the low frequencies. This con- trol provides 8dB of cut or boost at 150Hz.

9.Presence: This switch, when depressed, increases the output level of the high frequencies by 8dB at 10kHz, giv- ing a more “glassy” sound to the amplifier. This helps the output of the amplifier cut through “acoustically dead” rooms.

10.Overdrive Level: Use this control to adjust the output level of the Overdrive Channel.

11.Reverb: Use this control to adjust the amount of reverberation applied to the sig- nal. With the control fully counter clockwise no reverb is applied. As you rotate the con- trol clockwise the amount of reverb increas- es.

12.Lamp: This lamp illuminates when the amplifier is turned on.

13.On/Standby: Use this switch to acti- vate the amplifier. The On/Off switch (#14) should be turned on first. Allow 20 seconds for the amplifier to warm up before turning the Standby switch on.

14.On/Off: Use this switch to turn the amplifier on and off. This switch should be turned on at least 20 seconds before turn- ing the Standby switch (#13) on.

4

Image 4
Contents E R ’ S G U I D E Table of Contents I t a r a m p l i f i e r H E a DCongratulations Lamp This lamp illuminates when the amplifier is turned on Front PanelRear Panel Piggy Back Mounting onto the V212T Speaker Cabinet Brief History Of The Tube Important Information About Tubes and Tube ProductsTube Types And Usage Nature Of Tubes Why And When To Replace Them Importance Of Proper Biasing Survival Tips For Tube Amplifiers System Block Diagram Declaration of ConformityV30H Technical Specifications