NETGEAR Configuration and Wireless Repeating Function Guide for D6200

D6200 WiFi DSL Modem Router

The D6200 WiFi DSL modem router is always in dual-band concurrent mode, unless you turn off one radio. If you enable the wireless repeater in either radio band, the wireless base station or wireless repeater cannot be enabled in the other radio band. However, if you enable the wireless base station in either radio band and use the other radio band as a wireless WiFi DSL modem router or wireless base station, dual-band concurrent mode is not affected.

For you to set up a wireless network with WDS, the following conditions have to be met for both access points:

•Both access points have to use the same SSID, wireless channel, and encryption mode.

•Both access points have to be on the same LAN IP subnet. That is, all the access point LAN IP addresses are in the same network.

•All LAN devices (wired and wireless computers) have to be configured to operate in the same LAN network address range as the access points.

Wireless Repeating Function

Use the Wireless Repeating Function screen to view or change the wireless repeater settings.

To view or change the wireless repeater settings:

1. Select ADVANCED > Advanced Setup > Wireless Repeating Function.

2.Configure the following settings:

•Enable Wireless Repeating Function. Select the check box for the 2.4 GHz or 5 GHz network to use the wireless repeating function.

Advanced Settings

108