Pioneer VSX-C300-S manual Press Dimmer on the remote control re

				Additional Information
Symptom		Cause		Remedy
The sound distorts.	•	The analog signal is too strong.	• Turn on input attenuator (see page 28).
	• Master volume is too loud.		• Turn the volume down.
You can only hear treble	•	The FRONT speakers are set to small.	•	Set the FRONT speakers to large (refer
from speakers.				to page 26).
No image is output when	•	The video connections are incorrect.	• Make sure the video component is con-
an input is selected.	• The input source is not properly selected.			nected correctly (refer to pages 11 to 14).
			•	Make sure the proper component is se-
	• The DVD/video player settings are incor-			lected by pressing the correct function
				button (see page 20).
		rect.	•	Set correctly. Refer to the instruction
				manual supplied with the DVD/video
				player.
The settings have all been	•	The receiver has been unplugged or the	•	Set the receiver again (refer to page 24-
cleared.		main power turned off for more than a		29).
		month.
OVERLOAD blinks in the	•	There is a short in your speaker cable.	• Fix the short or get new speaker cable.
display and the power	•	The output is too high.	•	Turn the volume down.
turns off automatically.
You can't set the crossover	•	All the speakers are set to either large or	• Change the speaker settings (refer to page
frequency.		NO (i.e. no speakers are set to small).		26).
The display is dark or off.	•	The DIMMER feature is set to dark or off.	• Press DIMMER on the remote control re-
				peatedly to select a different brightness.
After making an adjust-	•	The DIMMER feature is set to off.	• Press DIMMER on the remote control re-
ment the display goes off.				peatedly to select a different brightness.
The receiver cannot be re-	•	The remote control batteries have worn	• Replace the batteries (refer to page 10).
mote controlled.		out.
	• You are too far away or at a bad angle for		•	Operate within 7 m, 30° of the remote
		operation.		sensor on the front panel (refer to page
	• There is an obstacle between the receiver			10).
			• Remove the obstacle or operate from an-
		and the remote control.		other angle of position.
	• Strong light such as fluorescent light.		• Avoid exposing the remote sensor on the
	• The remote is not in the proper mode to			front panel to direct light.
			•	Press RECEIVER button.
		control the receiver.
Other components cannot	•	The proper code hasn't been input into	•	Input the proper code into the remote
be remote controlled.		the remote control to control that com-		control (see page 42).
		ponent.
	•	The remote control is in a mode to make some	•	Press the button of the component you
		setting or control something on the receiver.		want to control.
	•	Something is plugged into the "Control	• Either point remote at the remote sensor
		Terminal in" (see page 17).		of the unit that is plugged into the "Con-
				trol Terminal in" or unplug the cable from
				the "Control Terminal in" and use remote
				normally.
The shutter of the optical	•	The plug was inserted improperly	•	The terminal is fine but the shutter won’t
terminal doesn’t close af-				close.
ter removing plug..

If the unit does not operate normally due to external effects such as static electricity.

Disconnect the power plug from the outlet and insert again to return to normal operating conditions.

English

51

En