Azden 311DRH, 31 HT, 32BT, 221R, 31 LT manual

Removing the 31XT:

Push down on the release button and pull out.

(1)Turn the bottom half of the case counter-clockwise until it is completely off.

(2)Insert one fresh alkaline “AA” battery into the compartment. Make sure battery polarity is correct. Replace the bottom half of the case and turn clockwise until snug. DO NOT OVERTIGHTEN.

(3)Frequency Label:

The frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receiver in use must also be on the same frequency.

(4)Power Off/On: Switches the transmitter off or on.

(5)Audio Off/On:

Slide the switch to “On” for normal operation. Slide it to “Off” to mute the audio.

NOTE: When turning the transmitter on, slide the Power “On” first, and then slide the Audio to “On”. When turning the transmitter off, first slide the Audio to “Off”.

(6) LED:

Turns RED when the Power is “On” and the Audio is “Off”. Turns GREEN when the Power and Audio are “On”.

(7) Level:

Turn clockwise to increase, or counter-clockwise to decrease the input level. A small screwdriver is supplied to make adjustments. The level control is factory-preset in the center position.

NOTE: Remove the battery if the transmitter will not be used for a long period of time.

31HT Handheld Microphone Transmitter:

(1)Turn the bottom half of the microphone case counter-clockwise until it is completely off.

(2)Insert one fresh Alkaline “AA” battery into the compartment. Make sure battery polarity is correct. Then, replace bottom half of microphone case and turn clockwise until snug. DO NOT OVER-TIGHTEN.

(9)