Audio Output Connector | Azden 221R, 31 HT, 32BT, 311DRH, 31 LT

(4) Audio Input Level Control

Turn clockwise to increase, or counter-clockwise to decrease the input level. A small screwdriver is supplied to make adjustments. The level control is factory-preset in the center position.

(5)3 Position Switch

The left position: OFF

The middle position: STANDBY

The right position: ON

In the “STANDBY” position, the audio is muted.

(6)LED Indicator

Turns red when the switch is in “STANDBY” position and green in “ON” position. NOTE: Remove the battery if the transmitter will not be used for a long period of time.

(7) Audio Output Connector

This 3.5mm mono connector is where the mic is plugged in. This connector was designed to be used with a special “screw-down” connecting jack that eliminates the possibility of the jack being accidentally pulled out. A standard 3.5mm mono jack can also be used but will not afford the extra protection.

(8) Metal Belt Clip

Used to attach the 32BT securely to a belt.

31XT Plug-in transmitter adaptor:

Note: The 31XT is designed to turn any wired dynamic metal-body microphone that has an XLR output into a wireless microphone.

Connecting the 31XT:

Disconnect the microphone cable from the microphone by pushing down on the release button where the microphone and cable connect. Connect the 31XT by lining up the pins on the microphone with the holes on the transmitter, and insert. Push the 31XT into the microphone until it locks into place.

(8)