Pioneer VSX-03TXH manual Before you start, Loading the batteries, Checking what’s in the box

Page 8

01Before you start

•iPod and USB Ready

This receiver has the terminals for connecting an iPod unit and a USB mass storage device.

The iPod terminal is ready for handling digital audio, and this receiver’s enhanced compatibility makes on-screen control of your iPod an added possibility.

The USB terminal allows you to listen to two-channel audio from a USB mass storage device connected to this receiver.

•XM and SIRIUS Ready

With the new XM and SIRIUS Radio terminals, you’ll be up and running in no time. This receiver’s enhanced compatibility makes XM HD Surround playback as well as on-screen control of XM and SIRIUS Radio an added possibility.

Loading the batteries

Main remote control unit:

Sub room remote control unit:

Checking what’s in the box

Please check that you’ve received the following supplied accessories:

•Setup microphone (cable: 5 m (16.4 ft.))

•Remote control unit

•Sub room remote control unit

•AA/IEC R6P dry cell batteries x4

•AM loop antenna

•FM wire antenna

•Warranty card

•These operating instructions

Installing the receiver

•When installing this receiver, make sure to put it on a level and stable surface.

Don’t install it on the following places:

–on a color TV (the screen may distort)

–near a cassette deck (or close to a device that gives off a magnetic field). This may interfere with the sound.

–in direct sunlight

–in damp or wet areas

–in extremely hot or cold areas

–in places where there is vibration or other movement

–in places that are very dusty

–in places that have hot fumes or oils (such as a kitchen)

Caution

Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:

•Never use new and old batteries together.

•Insert the plus and minus sides of the batteries properly according to the marks in the battery case.

•Batteries with the same shape may have different voltages. Do not use different batteries together.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

•WARNING

Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries.

8

En

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Operating Instructions Operating Environment Federal Communications Commission Declaration of ConformityKeep in a Secure AREA. this is for Your Security Information to UserRisk of Electric Shock Do not Open Wash hands after handling Contents Other Settings Using other functionsOther connections Hdmi ControlBefore you start Chapter FeaturesBefore you start Installing the receiver Before you startLoading the batteries Checking what’s in the boxMinute guide Minute guide ChapterIntroduction to home theater Listening to Surround SoundFollow the instructions on-screen CheckProblems when using the Auto Mcacc Setup Minute guidePlaying a source Select the input source you want to playPhase Control on 02 5 minute guide Better sound using Phase ControlPhase Control OFF Rear panel Connecting your equipmentConnecting your equipment Chapter Connecting your equipment Connecting your equipment About the video converterConnecting your equipment Connecting using Hdmi About HdmiConnecting your equipment Connecting your TV and DVD player Connecting your Blu-ray disc playerFor a second recorder, use the DVR2 in inputs Using the component video jacks Connecting digital audio sourcesAbout the WMA9 Pro decoder Connecting analog audio sourcesConnecting a component to the front panel inputs Connecting your equipment Installing your speaker system Connecting the speakersBanana plug connections Bare wire connectionsPlacing the speakers Connecting antennas THX speaker system setupPlugging in the receiver Connecting external antennasPlug the power cord into a power outlet Controls and displays Controls and displays ChapterFront panel 13 14Speakers Operating range of remote control unitControls and displays Controls and displays Display Controls and displays Remote control RECEIVERTV Ctrl SOURCEMute ReceiverControls and displays Sub remote control unit Listening to your system Listening to your system ChapterListening in surround sound Auto playbackUsing the Home THX modes Using the Advanced surround effectsListening to your system THX SELECT2 GamesTip Using Front Stage Surround AdvanceListening in stereo Listening to your system Using Stream Direct Selecting Mcacc presetsChoosing the input signal Hdmi Digital AnalogAuto Using surround back channel processingUsing the Virtual Surround Back mode Sources Using the tuner Using the tuner ChapterSaving station presets Listening to the radioUsing the tuner Naming station presetsListening to station presets AbcdefghijklmnopqrstuvwxyzSystem Setup menu System Setup menu ChapterMaking receiver settings from the System Setup menu Select the setting you want to adjustSystem Setup menu Custom Menu The default is ALL recommendedSetting , Channel Level , Speaker Distance and EQ Options are ALL , Keep SP System , 6 SpeakerIf necessary, confirm the speaker configuration in the OSD.1 Surround back speaker setting Manual Mcacc setupAdjust the level of the left channel Select ‘Fine SP Distance’ from the Manual Mcacc setup menuFine Channel Level Fine Speaker DistanceAcoustic Calibration EQ Adjust Select ‘Standing Wave’ from the Manual Mcacc setup menuAdjust the parameters for the Standing Wave Control Select ‘EQ Adjust’ from the Manual Mcacc setup menuHow to use Acoustic Calibration EQ Professional How to interpret the graphical outputSelect the channels you want and adjust to your liking Acoustic Calibration EQ ProfessionalSelect an option and press Enter Using Acoustic Calibration EQ ProfessionalSelect ‘EQ Professional’, then press Enter Select ‘Data Management’ from the System Setup menu Data ManagementChecking Mcacc preset data Copying Mcacc preset dataRenaming Mcacc presets Clearing Mcacc presetsSystem Setup menu Manual speaker setup Speaker SettingSelect ‘Manual SP Setup’, then press Enter Select ‘Speaker Setting’ from the Manual SP Setup menuSelect a setup option Confirm your selected setup optionAdjust the level of each channel using / Channel LevelCurve THX Audio SettingSpeaker Distance 5e.THX Audio Setting Loudness Plus SB SP Position Finish Connecting an iPod Connecting your iPod to the receiverOther connections Other connections ChapterSwitching the iPod controls2 Press iPod Ctrl to switch the iPod controls.3Other connections Basic playback controlsOther connections Connecting a USB device Connecting your USB device to the receiverBasic playback controls Connect your USB device.3Compressed audio compatibility Using XM RadioConnecting your XM Radio receiver Saving channel presets Using XM HD SurroundListening to channel presets Listening to XM RadioUsing Sirius Radio Using the XM MenuConnecting your SiriusConnect Tuner Press Sirius to switch to the Sirius inputListening to Sirius Radio Using the Sirius MenuPress / to select the channel preset you want Other connections Connecting the multichannel analog inputs Speaker B setupSwitching the speaker system Selecting the multichannel analog inputsConnect your speakers as shown below Bi-wiring your speakersBi-amping your front speakers Other connections Connecting additional amplifiers MULTI-ZONE listeningMaking MULTI-ZONE connections LargeUsing the MULTI-ZONE controls Basic MULTI-ZONE setup ZoneSurround Back System MULTI-ZONE setup Zone MULTI-ZONE listening optionsConnecting an IR receiver MULTI-ZONE remote controlsUsing this receiver with a Pioneer flat panel TV Pioneer flat panel TVUsing the SR+ mode with a Pioneer flat panel TV Select ‘Output PC’ and press Enter Other connections Connecting a PC for Advanced Mcacc outputAdvanced Mcacc output using your PC Setting the Hdmi options Setting the Hdmi Control modeHdmi Control Hdmi Control ChapterBefore using synchronization Synchronized amp modeHdmi Control About Hdmi ControlOther Settings Other Settings ChapterInput Setup menu SetupOther Settings Other Setup menuInput function default and possible settings Press Receiver on the remote control, then press SetupMulti Channel Input Setup Zone Audio SetupSR+ Setup for Pioneer flat panel TVs OSD AdjustmentSelect ‘SR+ Setup’ from the Other Setup menu Select the ‘PDP Volume Control’ setting you wantUsing other functions Using other functions ChapterSetting the Audio options Press Return to confirm and exit the menuUsing other functions Setting the Video optionsUse / to select the setting you want to adjust Press RECEIVER, then press Video ParameterMaking an audio or a video recording Select the source you want to recordPrepare the source you want to record Prepare the recorderUsing the sleep timer Switching the speaker impedanceChecking your system settings Dimming the displayUsing other functions Resetting the system Default system settingsPress the front panel Auto SURR/STREAM Direct button Press Home THX to confirmSetting the remote to control other components Selecting preset codes directlyPreset code list Controlling the rest of your systemControlling the rest of your system Controls for TVsTV On or offControls for other components Decide which component you want to use the remote sensor Menu & Enter DisplayTroubleshooting PowerAdditional information Additional information ChapterAdditional information Other audio problems Settings VideoDisplay Signal SEL buttonProfessional Calibration EQ graphical output Remote control USB interfaceOr other setting for your component Other setting for your componentReceiver to a component or TV with the DeepColor feature Hdcp Error showsConfiguration a Configuration BImportant information regarding the Hdmi connection XM radio messagesSirius radio messages Additional information Surround sound formats DolbyWindows Media Audio 9 Professional DTS Digital SurroundDTS Neo6 DTS 96/24Additional information About THX About Neural THX Surround XM Ready Subscription Additional information About XMAbout XM Radio XM Ready Legal PRO Logic Stereo 2 channel signal formatsON/AUTO PRO Logic +THX Multichannel signal formats DTS +Neo6 DTS +Neo6 +THX Cinema Pro Logic llx Music +THX a EX +THX Games bConnected Not connectedAdditional information Specifications Cleaning the unitDecibel Level Example To establish a safe levelOnce you have established a comfortable sound level Pioneer Corporation

VSX-03TXH specifications

The Pioneer VSX-03TXH is a versatile and powerful AV receiver designed to elevate your home entertainment experience. Known for its robust build quality and advanced features, the VSX-03TXH caters to audiophiles and casual viewers alike, providing rich audio and immersive surround sound capabilities.

One of the standout features of the VSX-03TXH is its 9.2-channel high current amplification, which delivers 130 watts per channel. This allows for a dynamic soundstage and excellent power handling, ensuring that every detail in your favorite movies and music is accurately reproduced. The receiver supports various audio formats, including Dolby Atmos, DTS:X, and IMAX Enhanced, enabling an immersive audio experience that makes you feel like you are part of the action.

Additionally, the VSX-03TXH comes equipped with Pioneer's proprietary MCACC (Multichannel Acoustic Calibration System). This technology analyzes the acoustic characteristics of your room and automatically adjusts speaker settings to optimize sound quality. This means you can enjoy the best possible audio performance, regardless of your room's layout.

The connectivity options on the VSX-03TXH are extensive, featuring multiple HDMI inputs and outputs, including support for 4K video pass-through, HDR, and HDCP 2.2. This ensures that your receiver is future-proof and can handle the latest video technology, making it a perfect match for modern 4K TVs and gaming consoles. Furthermore, the receiver supports HDBaseT, which allows for long-distance audio and video transmission, making installation more flexible.

In terms of streaming capabilities, the VSX-03TXH is equipped with Wi-Fi, Bluetooth, and Chromecast built-in, providing seamless access to your favorite music streaming services. Users can enjoy wireless listening and even multi-room audio with the help of compatible devices. The receiver also includes various digital and analog inputs, making it easy to connect a range of media devices.

The elegant design of the VSX-03TXH features an intuitive user interface and a clear, informative display that simplifies navigation. This allows you to quickly adjust settings or switch inputs without hassle. Overall, the Pioneer VSX-03TXH represents a powerful combination of high-end audio technology, robust functionality, and user-friendly features, making it an excellent choice for any home theater system.
Top Page Image Contents