OWI CRS-101 installation instructions Typical CRS System Connections

Figure 14. Typical CRS System Connections

CONNECTIONS

The CRS-101 System requires only a few simple connections and sets up in minutes. The only required connections are the IR Sensors, Speakers and Power Cord. Connecting an optional audio source such as a CD/DVD Player, VCR, Computer, Projector, Cable, Satellite, etc is also simple using standard RCA- RCA audio patch cables.

IR Sensors

1.Connect the CRS-IRS IR Sensor mini plugs to any two of the three IR Sensor Inputs on the CRS- CASE Side Panel.

Speakers

1.Strip approximately ¼” off each lead and twist the ends so there are no loose strands that can cause shorts. The recommended speaker wire size is 14 to 16 gauge.

2.Connect to the appropriate + and – Speaker Terminal. Maintain polarity from the speaker.

NOTE: Though the CRS has Left and Right Line Inputs, the Speaker Outputs are mono, so BOTH channels will be output from BOTH speakers.

15