Numark Industries CD MIX-1 manual Rear Panel Features

CD MIX-1

REAR PANEL FEATURES

1.Channels Inputs - Unbalanced RCA jacks for connecting external sources. The Phono/Line Input is selected with the toggle switch on the front panel. You can connect stereo audio from Turntables, HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

NOTE: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector.

2.GND - Grounding lug for turntable connection. Always use this connection when using turntables. (your turntable cable should have a grounding wire)

3.Line/Phono Input switch - Use this to allow either line level or phono level equipment to be plugged into your channel inputs. When Phono input is selected, your signal is fed directly to the high-quality RIAA phono pre-amplifiers. Use this position only for turntables. Line level sources will overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

4.Record Outputs - Unbalanced RCA jacks used to send the output of the program any connected recording device.

5.Stereo Main Outputs - Unbalanced RCA connectors controlled by the Master fader.

6.Balanced Main Outputs - Low-impedance XLR type connectors controlled by the Master fader.

7.Mic Input – Plug your 1/4” Microphone plug in here.

8.Power Connector - Plug in power adapter here and check the voltage level to match your country’s standard.

9.Power Switch – Turn on unit here.

	- The Leader in DJ Technology
©1999 Numark Industries	- 10 -	http://www.numark.com