Pioneer VSX-52TX Dynamic Range Control Setup, Dual Mono Setup, Choose the setting that you want

Other Settings

4 Select the setting you want to adjust.

If you are doing this for the first time, you may want to adjust these settings in order:

6.	Other Setup
[		]
	a . DRC Setup
[	b . Dual Mono Setup	]
[	c . LFE ATT Setup	]
[	d . SR+ Setup	]
[	e . Multi Room Setup	]
[	f . 12V Trigger Setup	]

•DRC Setup – Specify the amount of dynamic range adjustment to Dolby Digital soundtracks (see Dynamic Range Control Setup below).

•Dual Mono Setup – Isolate one channel when listening to discs with dual mono encoding (see Dual Mono Setup below).

•LFE ATT Setup – Choose the attenuator level for the LFE channel (LFE Attenuator Setup on page 66).

•SR+ Setup – Specify how you want to control your Pioneer plasma display (SR+ Setup for Pioneer plasma displays on page 66).

•Multi Room Setup – Specify your volume setting and IR receiver type for a multi-room setup (see Multi Room Setup on page 67).

•12V Trigger Setup – Specify which components are switched on or off using the 12 volt trigger (see 12 Volt Trigger Setup on page 67).

5Make the adjustments necessary for each setting, pressing RETURN to confirm after each screen.

Dynamic Range Control Setup

• Default setting: OFF

This setting specifies the amount of dynamic range adjustment to Dolby Digital and DTS movie soundtracks. You may want to use this when listening to surround sound at low volumes.

1 Select ‘DRC Setup’ from the Other Setup menu.

6.	Other Setup
[		]
	a . DRC Setup
[	b . Dual Mono Setup	]
[	c . LFE ATT Setup	]
[	d . SR+ Setup	]
[	e . Multi Room Setup	]
[	f . 12V Trigger Setup	]

11

2 Choose the setting that you want.

6a. DRC Setup

DRC [ OFF ]

•OFF – No dynamic range adjustment (use when listening at higher volume).

•MID – Mid setting.

•MAX – Dynamic range is reduced (loud sounds are reduced in volume while quieter sounds are increased).

3When you're finished, press RETURN. You will return to the Other Setup menu.

Dual Mono Setup

•Default setting: CH1

You can specify how dual mono encoded Dolby Digital soundtracks should be played. Dual mono is not widely used, but is sometimes necessary when two languages need to be sent to separate channels.

1Select ‘Dual Mono Setup’ from the Other Setup menu.

6.	Other Setup
[	a. DRC Setup	]
[	b. Dual Mono Setup	]
[	c . LFE ATT Setup	]
[	d. SR+ Setup	]
[	e . Multi Room Setup	]
[	f . 12V Trigger Setup	]

2 Choose the setting that you want.

6b. Dual Mono Setup

Dual Mono

[ CH1 ]

•CH1 – Only channel 1 is played

•CH2 – Only channel 2 is played

•CH1 CH2 – Both channels are played through the front speakers

3When you're finished, press RETURN. You will return to the Other Setup menu.

65

En