Step 4. Adjust the corresponding tuner's volume control so that its knob points to the 2 o'clock position. If the tuner's AF PEAK indicator remains lit, readjust the microphone's audio level control to the position that causes the indicator to flash when the tuner output level reaches its peak. The AF PEAK indicator lights when the output level reaches the point of about 3 dB below the clipping level.
Note
The AF PEAK indicator operates in response to the volume control position.
However, the AF LEVEL indicator (on the
Step 5. Replace the battery cover.
12. LICENSE REQUIREMENT
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
13. SPECIFICATIONS
[ WM-4310 ]
Microphone Element | Electret condenser type, cardioid pattern |
Emission | F3E |
|
|
Frequency Range | 690 – 865 MHz, UHF |
|
|
Selectable Channel | 16 channels |
|
|
RF Carrier Power | Less than 50 mW |
|
|
Tone Frequency | 32.768 kHz |
|
|
Modulation System | PLL synthesizer |
|
|
Maximum Input Level | 120 dB SPL |
|
|
Battery | 6LR61 (9 V x 1) |
|
|
Battery Life | 10 hours (alkaline) |
|
|
Indicator | Power/Battery lamp (common use) |
|
|
Antenna | 1/4 λ herical type |
|
|
Operating Temperature | |
|
|
Finish | Resin, coating, dark gray |
|
|
Dimensions | 62 (w) x 142 (h) x 32 (d) mm |
|
|
Weight | 150 g (with battery) |
|
|
Note: The design and specifications are subject to change without notice for improvement.
• Accessories |
|
Screwdriver (for setting) | 1 |
Channel identification seal | 1 |
Storage case | 1 |
7