Console Specifications
CS – 0206VLII
4/4/2006
Page 5 of 7
Power Strip mounts and/or modular electrical power runs (electrical
distribution option that brings in (4) – 20 amp or 15 amp circuits to
the console) are made available in the frames cable management
and again are accessible from either the front or rear of the
cabinets. Storage cabinets that support the storage of CPUs are
also to be designed with cable management and power support.
6.5 Panels -
Side Panels are constructed from .75” thick laminated particle board.
Storage cabinet panels are constructed of 18 gauge cold rolled steel to
provide durability and strength.
6.6 Work Surfaces and Adjustable Work Surfaces –
The console shall have a minimum 1.25" (50mm) thick work surface with
post-formed edge, T-Mold or specific edging for operator comfort. Work
surfaces are constructed of high-pressure post-formed grade laminate
applied to .45 lb. industrial grade board for durability. A thermal fused
melamine backer is applied to seal the board and eliminate rough surfaces
on the underside of the work surface and to prevent moisture access to
the work surface.
The ability to lift the keyboard work surface is achieved by a mechanical
device that is used for the lift of the keyboard work surface. You have the
ability to adjust 12” vertically from the position of the main work surface (6”
above and 6” below).
6.7 Keyboard Management -
Keyboard management options consist of:
a. Keyboards on the work surface
b. Keyboards on a specific keyboard surface utilizing a mechanical
lift assembly.
c. Rollout keyboards below the work surface
d. Keyboard switch (operating a min. of 2 or 3 monitors - KVM)
e. Articulating keyboard and mouse platform
6.8 Exterior End Panels
The exterior panel elements shall be attached to the console structure by
means of concealed hardware.