Console Specifications
CS – 0206VLII
4/4/2006
Page 1 of 7
Specifications (Vision Line II) - 1) Vision Line II General Description
1.1 For this point forward SMC shall be referred to as the console
contractor.
1.2 Vision Line II is a console that is designed to accommodate numerous
kinds of computers, communication equipment, and user interface devices
(ex. Keyboards, mice, etc.).
The console is to be a design that is completely modular, totally
interchangeable and easily reconfigured by the user. There are to be
different frame widths (24”, 30”, 36”, 48”, 60” and 72”) that are standard.
There are 90-degree corners along with wedge designs that allow for
Convex and Concave layouts (they are to be available in 30, 45 and 60-
degrees). Standard height of the console is 43”. All units are bolted
together allowing total design flexibility.
The frames are constructed in such a manor as to allow back-to-back
configurations in straight, convex, and concave layouts. The frame itself
remains the center spine for the back-to-back work surfaces with access
to cable management from either side of the frame’s front and the top.
There are numerous options such as peninsulas, binder storage, and
storage cabinets.
1.3 The consoles shall accommodate a variety of computers,
communication equipment, CRT or Flat Panel displays and operator
interface devices. The design of the consoles should also satisfy the
functional, ergonomic and aesthetic requirements of the operational
working environment.
1.4 Construction -
All construction supplied by the contractor shall be of such a design
that will allow for 24/7 utilization of the consoles supplied.
Constructed of formed cold rolled steel, this open architecture
design provides:
The frames are to be constructed from 14 Ga.* cold roll steel (as a
minimum) to support all of the required accessories, work surfaces,
cables, and user interfaces.