Revolabs 03-HDVENUCH manual

Move the microphone closer to the Base Station and the connection will automatically be re- established to its original state, and the beeping will cease. If not, the microphone will continue beeping until it turns off in about 15 minutes.

Using the HD Directional Tabletop Wireless Boundary Microphones

The HD Tabletop Wireless Microphone, shown below, is designed to provide optimum coverage when placed on a conference room table in front of one or two people.

Pickup	45	6
patter	45

			5
	1
	2	3	4
		3	4
1.	LED display — visual status for mute, un-mute, and pairing.
2.	Rubber feet — non-slip, vibration absorbing pads.
3.	Audio jack — accepts a 2.5mm plug.
4.	Charging port — docks to Revolabs HD Charger Bases.
5.	Mute button — press to mute, un-mute and pair microphone.
6.	Acoustic Cover — protects microphone element (non-removable).

To use the HD Directional Tabletop Microphone:

1.Remove the microphone from the Charger Base to turn on and automatically mute the mic. (indicated by a flashing RED LED)

2.Directional Tabletop microphones should be located on the table with the acoustic cover pointed toward the users, trying to keep the microphone 2 to 5 feet (0.6 to 1.5m) from the target person or two. The pick-up pattern for this directional microphone is ~+/- 45º to either side of directly in front of the microphone. It is always better to be as close to the person speaking as possible, but avoid placing the microphone where it might be blocked by equipment or paperwork. Avoid placing microphones too close to an audio or video conference speaker to avoid echoes. Make sure that the microphone is always placed lying on its rubber feet atop a flat surface. Refer to diagram below:

3.With the microphone in position, un-mute the microphone by pressing and releasing the Mute button (confirm by a flashing GREEN LED).

-12 -

Acoustic Cover — protects microphone element (non-removable).