4
Pro Series 5 Installation and Operation
Transmitter Setup, Controls and Functions
Battery Selection and Installation
Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment.
Trim Control | Channel Selector |
|
|
|
|
| |||||
(Volume) |
| Switch |
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ScrewdriverBattery
Compartment
Figure C — Handheld Transmitter
Indicator LED
(Power/Mute/Battery)
Handheld Transmitter Battery Installation
1.Unscrew the lower body cover, slide it downward, and remove it to expose the battery compartment.
2.Observe correct polarity as marked inside the battery compartment
and carefully insert two fresh 1.5V AA alkaline batteries. Insert the first battery and slide it toward the spring contact. Then insert the second battery into the space remaining. Make certain the batteries are fully seated in the battery compartment. (Fig. C)
3.Slide the lower body cover back on and screw the housing together. Do not overtighten.
Power/Mute Button
Note: Remove batteries from the handheld transmitter starting at the bottom end, where finger indents in the battery housing are provided for easy grip.
Handheld Transmitter Battery Condition Indicator
After the battery is installed, press and hold the Power/Mute button until the indicator LED turns green (Fig.C). (It will turn red first; keep holding until it turns green). If the indicator LED does not light up when the Power/Mute button is pressed, the batteries are installed incorrectly or they are dead. The LED will flash to indicate
Handheld Transmitter Mute Function
With the transmitter on, a slight touch of the Power/Mute button will toggle between muted and unmuted operation. Red LED indicates muted operation. Green LED indicates unmuted operation.