Pioneer VSX-517-S/-K manual Additional information Chapter, Troubleshooting, Problem Remedy

Page 58

11Additional information

Chapter 11:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.

Problem

Remedy

The power does not turn on.

• Disconnect the power plug from the outlet, and insert again.

 

• Make sure there are no loose strands of speaker wire touching the

 

rear panel. This could cause the receiver to shut off automatically.

 

• If the power shuts off automatically, take the unit to your nearest

 

Pioneer authorized service center or your dealer for servicing.

 

• The unit may have been switched on using the wrong voltage

 

setting. Make sure you switch the VOLTAGE SELECTOR on the rear

 

panel to the right voltage for your country or region, then reset the

 

unit (page 60) before switching on again.

No sound is output when a function is selected.

•Make sure the component is connected correctly (refer to Connecting up on page 12).

•Press MUTE on the remote control to turn muting off.

No image is output when a function is selected.

•Make sure the component is connected correctly (refer to Connecting up on page 12).

•Select the correct component (use the input select buttons).

Considerable noise in radio

• Connect the antenna (page 18) and adjust the position for best

broadcasts.

reception.

 

• Route any loose cables away from the antenna terminals and wires.

 

• Fully extend the FM wire antenna, position for best reception, and

 

secure to a wall (or connect an outdoor FM antenna).

 

• Connect an additional internal or external AM antenna (page 18).

 

• Turn off equipment causing interference or move it away from the

 

receiver (or move antennas farther away from equipment causing

 

noise).

 

 

Broadcast stations cannot be

• Connect an outdoor antenna (refer to page 18).

selected automatically.

 

 

 

58

En

Page 57 Page 59
Image 58
Page 57 Page 59
Contents VSX-517-S/-KVSX-817-S/-K Important the Moulded Plug Risk of Electric Shock Do not OpenVentilation Caution Voltage selectorOperating Environment Contents Power cord caution Specifications Cleaning the unit Bi-wiring your speakersTroubleshooting Resetting the main unit Other connectionsBefore you start Chapter Before you startChecking what’s in the box Loading the batteries Installing the receiver Operating range of remote control unitBefore you start Introduction to home theater Minute guide02 5 minute guide Chapter Listening to Surround SoundMinute guide Using the Quick SetupNederlands Español Automatically setting up for surround sound Mcacc 02 5 minute guideOther problems during Auto Mcacc EnterConnecting up Chapter Connecting upMaking cable connections Connecting up Connecting a TV and DVD player Connect a set of audio/video outputs on Connecting upConnecting the multichannel analog outputs VSX-817 model Use an optical cable forAbout the WMA9 Pro decoder Connecting other audio components132 Connecting other video components Using the component video jacksComp 1 DVD Comp 2 TV Comp 3 DVR Connecting to the front panel video terminalConnecting to the front panel audio mini jack See Assigning the component video inputs onTo improve FM reception Connecting up Connecting antennasUsing external antennas To improve AM receptionConnecting up Connecting the speakers VSX-517 model Hints on speaker placementSpeaker terminals VSX-817 modelOverhead view of speaker setup Speaker placement diagramsView of 7.1 channel speaker setup Following illustrations show 7.1 channel speaker setups.1Front panel Controls and displaysControls and displays Chapter STANDBY/ONControls and displays Controls and displays Display Remote control VSX-817 ADV.SURR PhaseMaster Volume + DialogSubtitle Access6TUNE/ST +/- /ENTER RECInfo Remote control VSX-517Signal ShiftDVD/DVR Volume +Input Selector buttons 10 /ENTER12 DVD/DVR control buttons Switches between the three banks classes of station presetsConfirm and exit the current menu screen Tuner controlsAuto playback Listening to your systemListening to your system Chapter Listening in surround soundSetting What it does Setting the effect optionsUsing the Advanced surround effects Listening to your systemListening in stereo Using Front Stage Surround AdvanceStereo See Listening in stereo above for more on this Listening with Acoustic Calibration EQ Listening to your system Using Stream DirectChoosing the input signal AUTOSURR. See Auto playback onUsing Virtual Surround Back VSB VSB OFF Virtual Surround Back mode is switched offUsing Phase Control Press Phase Phase Control to switch on phase correctionUsing the Sound Retriever Listening to your system Using Midnight and LoudnessUsing the tone controls Enhancing dialogSelecting the front audio inputs Selecting the multichannel analog inputsUsing the System Setup menu System Setup menuSystem Setup menu Chapter Surround back speaker settingManual Mcacc speaker setup System Setup menuFine Channel Level Acoustic Calibration EQ Fine Speaker DistanceDeutsch Copying your Acoustic Calibration EQ settings Setting the Acoustic Calibration EQ manuallySpeaker setting Manual speaker setupChecking your Acoustic Calibration EQ settings Crossover network Channel levelAssigning the digital inputs Input Assign menuSpeaker Distance Assigning the component video inputsDual Mono Setup Other setup menuDynamic Range Control Setup LFE Attenuator SetupSaving station presets Using the tunerUsing the tuner Chapter Listening to the radioChanging the frequency step Using the tunerListening to station presets Press AM or FM to select the tunerMaking recordings Chapter Making recordingsMaking an audio or a video recording Use the number buttons to enter the preset code Setting the remote to control other componentsSelecting preset codes directly Controlling the rest of your systemClearing all the remote control settings Controlling the rest of your system Direct functionInput Controlling the rest of your system Controls for TVsButtons Function Components SelectDisc Controlling the rest of your systemControls for other components Button s Function ComponentsCH + Function ComponentsEnter Guide HDDDVD Recorder Controlling the rest of your system Preset Code ListOn digital STB Manufacturer CodeOther connections Second Zone speaker B setupSwitching the speaker system Other connections ChapterOther connections Bi-amping your front speakers Bi-wiring your speakersFrançais Additional information TroubleshootingProblem Remedy Additional information ChapterAdditional information Phase ControlLfeatt Press Setup to confirm Additional information Resetting the main unitPower cord caution OK? shows in the displayAdditional information Specifications Miscellaneous Cleaning the unitAM Tuner Section Furnished PartsPioneer Corporation

VSX-517-S/-K specifications

The Pioneer VSX-517-S/-K is a noteworthy addition to the realm of home theater receivers, offering a blend of performance, versatility, and user-friendly features. This model is popularly recognized for its impressive audio capabilities, making it a great choice for both casual listeners and audiophiles alike.

One of the key features of the VSX-517 is its 5.1 channel surround sound system. This allows users to enjoy immersive audio experiences, whether they are watching movies, playing video games, or listening to music. The receiver delivers a robust power output, enabling dynamic sound reproduction that can fill a room, enhancing the overall entertainment experience.

The VSX-517 is equipped with Dolby Digital and DTS decoding technologies, which are staples in the industry for delivering high-quality sound reproduction. This ensures that the audio is as close to the original recording as possible, providing an engaging listening experience. Additionally, the receiver supports a range of other audio formats, allowing users to enjoy their favorite media without restrictions.

Another attractive feature of the VSX-517 is its advanced setup options. The receiver includes an on-screen graphical user interface that simplifies the installation and configuration process. This user-friendly interface allows users to easily adjust settings according to their preferences, making it more accessible for those who may not be tech-savvy.

The VSX-517 also boasts multiple inputs and outputs, including HDMI, component, composite, and digital audio inputs, ensuring compatibility with various devices such as Blu-ray players, gaming consoles, and streaming devices. This versatility means that users can connect their entire entertainment system to one central hub, streamlining their setup.

In terms of user convenience, the remote control is designed for intuitive operation, allowing easy access to essential functions such as volume control, input selection, and audio adjustments directly from the comfort of the couch.

The amplifier section of the Pioneer VSX-517 features Class D technology, which contributes to its efficiency. This means that the device can produce a remarkable sound output while consuming less power, making it an eco-friendly option for users.

Overall, the Pioneer VSX-517-S/-K stands out for its combination of strong audio performance, versatility in connectivity, and user-friendly features, making it an appealing choice for consumers looking to elevate their home entertainment experience without breaking the bank.
Top Page Image Contents