Fostex FM-3 owner manual Output status display, Limiter switch status, AUX OUT switch status

<Memo>: If you switch the microphone power supply switch of INPUT 1 to “T12”, the input sta- tus display changes as below.

If you set the microphone power supply switch of INPUT 1 to “T12” and set the microphone power supply switches of INPUT 2 and INPUT 3 to “P48”, the input status display looks as follows.

(3)Press the [EDIT] key to exit the status display mode.

The display changes to the meter display.

<Note>: If you need to supply the T12 power, set the T12 power supply function to “ENA” by the similar procedure as above.

<Memo>: The T12 disabled/enabled setting re- mains even after you turn off the unit. However, if you initialize the flash memory using the system status display, it is reset to the default setting (En- abled).

Output status display

On the output status display, not only you can see the current status of the following switches, but also you can set the threshold and ratio of the limiter. The follow- ing shows the default setting when the unit is shipped.

Front panel Right side panel

	Right side panel
Right side panel

The following icons are shown according to the switch setting.

• [LIMITER] switch status

When the [LIMITER] switch is set to “OFF”, the param- eter boxes for the threshold and ratio show “”.

When the [LIMITER] switch is set to “ON” or “LINK”, the parameter boxes for the threshold and ratio show the current parameter values.

You can edit the parameter values by following the pro- cedure described in the next page.

Switch	OFF	ON	LINK
setting
Icon	THRE
	RATIO

• AUX OUT switch status

Switch	OFF	1/2	2/3	1/3	L/R	L+R
setting
Icon

• AUX OUT level switch

Switch	-10	-60
setting
Icon

•SUB OUT level switch

•MAIN OUT (L, R) level switches

Switch	+4	0	-20	-60
setting
Icon

17