DJ Roller™ | Optional Remote |
|
|
The MINI/C controller may be purchased separately allowing you to control the main unit, and any others connected to it, while it is in stand alone mode. You can set the unit to blackout. If you have more than one unit, make sure the remote control is plugged into the first unit in the daisy chain. The remote control will not have any effect if the unit is in DMX mode. When the unit is in blackout mode, the light will come on next to the blackout button.
The DJ Roller™ may be controlled by a wide range of controllers such as the American DJ® Show Designer,™ or DMX Operator.™ A basic blackout controller (MINI/C) may also be used with the DJ Roller.™
MINI/C features:
30 ft. cable
Stand-By (Blackout)
©American DJ Supply® - www.americandj.com - DJ Roller™ Instruction Manual Page 9
DJ Roller™ | Cleaning |
|
|
Due to fog residue, smoke, and dust, cleaning the internal and external optical lenses must be carried out periodically to optimize light output.
1.Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2.Use a brush to wipe down the fan grill.
3.Clean the external optics with glass cleaner and a soft cloth every 20 days. Situation may very. If used heavily in clubs with lots of fog, cleaning may be required more often.
4.Clean the internal optics with glass cleaner and a soft cloth every
5.Always be sure to dry all parts completely before plugging the unit in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue, dust, dew).
DJ Roller™ | Lamp & Fuse Replacement |
|
|
Always replace with the exact same type lamp and fuse, unless otherwise specified by an authorized American DJ® service tech- nician.
Caution: Always disconnect the units main power before performing any type of service or fuse replacement! Always disconnect the main power before attempting to replace the lamp.
Lamp Replacement:
1.Be sure to follow proper procedures when handling halogen lamps.
2.Lamp replacement has been made simple by incorporating the use of a removable lamp tray and thumb screws.
3.Loosen the thumb screw on rear cover.
4.Remove the tray.
5.Remove and replace the bulb.
6.Reassemble.
Fuse Replacement: To replace the protective fuse, use a flat head screwdriver to unscrew and remove the fuse holder. Gently remove the old fuse and replace it with a new one. Insert the fuse holder back into the fuse housing and tighten.
For any other service related issues, please contact American DJ® customer support.
©American DJ Supply® - www.americandj.com - DJ Roller™ Instruction Manual Page 10