installation
Table of Contents | sections | 1 | 2 | 3 |
Step 3 Connecting Computers to the Switch 3..1 Make sure all computers are powered off.
3..2 Using the Belkin Dual DVI/USB KVM Cable Kit, connect the computers to a port on the rear of the KVM Switch. (Refer to diagram on page 8)
Note: The Cable Kit must be connected directly to a free USB port on your computer, with no USB hubs or other devices in between.
4 | 5 | 6 | 7 | 8 |
Step 4 Powering Up the Computers
Power up all the attached computers and check for display and peripheral functionality. All computers can be powered on simultaneously.
Note: Your computers should recognize the Switch and automatically install the HID USB driver if necessary. Refer to the Troubleshooting section of this manual if you are having problems with the USB keyboard or mouse.
When you power on your computers, the Switch emulates both a mouse and keyboard on each port and allows your computers to boot normally. The computer connected to port “1” will be displayed on the monitor. Check to see that the keyboard, monitor, and mouse are working normally. Proceed to do this with all occupied ports to verify that all computers are connected and responding correctly.
If you encounter an error, check your cable connections for that computer and reboot. If the problem persists, please refer to the Troubleshooting section in this User Manual.
Secure | 12 |
