Precautions, Inspection, Getting Started

Precautions:

1.Never operate unit when case is open.

2.Never cover unit as this may block air vents and cause overheating and possible fire hazard.

3.Never operate unit in the rain or in damp moist conditions as this could cause electric shock.

4.Follow standard electrical safety precautions when installing, operating or

servicing the unit to prevent electrical shock, fire, or equipment damage. 5.Make sure head and yoke rotate freely

6.These units are for commercial use and contain no user-serviceable parts inside. Servicing must be conducted by qualified service personnel.

Getting Started

Section 1

Lamp Replacement: Remove knurled knob on top of unit.

Remove top cover. Remove and replace lamp.

Make sure to clean fan

openings, air channels an fan gratings at regular intervals

Inspection

Every MAX™ projector has been thoroughly tested and shipped in perfect condition. Carefully unpack the projector and remove the bag with components from the carton. Inspect equipment for shipping damage.

Packing list:

1. The Max™ Projector

2.IEC power cord

3.Operating manual

4.MC-10 XLR female to male 10’ cable Caution:

ALWAYS LIFT AND MOVE THE UNIT BY ITS BASE AND NEVER BY THE YOKE OR HEAD!

Projector Installation

1.Unit can be hung or placed in any position.

2.Make sure to use a minimum 35Kg rated clamp,and are mounted securely and safety wire is used

3.Allow enough space on all sides for proper cooling.

4.Connect IEC power cord to side of unit.(7)

5.Plug cord into properly grounded socket.

*Check that the voltage marked on the back of unit is correct for your area.

6.Set the DMX ADDRESS (3) on control panel to desired settings (ie. Sound controlled and or master / slave, DMX address). Refer to side panel for settings.

7.Turn on power switch, lamp will light and unit will make a clicking noise and reset and wait for signal from controller

*The shutter is closed in stand-by mode, so it will be difficult to tell if the lamp is lit without a controller.

8.If stand-alone mode is chosen (10,1 on), unit will start a pre-programmed show any other units connected to this will sync with the master unit.

9.If Stand-alone mode with sound activation is chosen (10 on), unit will wait for sound to start a pre-programmed show and will operate as long as it senses sound.

*Unit may smoke for a few minutes until dust and excess paint is burned off by the lamp.